1992 MUSTANG 331 STROKER DRAG RACE 1.59 60ft 11 5@117 PULING THE TIRES OFF THE GROUND

THIS IS MY NEWEST 1/4 MILE RUN 08-07-2009 AT ENGLISHTOWN RACEWAY PARK NJ i PULLED A 1.59 60ft 11 5@117 PULING THE TIRES OFF THE GROUND ABOUT 6 INCHES

More Videos...


1988 Mustang Coupe Built 331 project
331 Stroker ,2 stages of NOS,5 spd,billet flywheel,alum drive shaft,pro 5.0 shifter,full 'thane bushings,steeda upper adjustable control arms,lakewoods,pillow ball adjusters,msd 6al,holley,edelbrock,etc. Dynoed at 525 the motor was built by Mark at Steve Ashworth performance in Fuquay Varina Nc. The car was sold to purchase the 65 prostreet coupe in the other vid.





Ford Mustang Crash And Fail Compilation
In this video you will find all the best Mustang crashes you can find anywhere else, there was so much footage it took 20 minutes to get it all in one video! I hope you all enjoy the video and dont forget to look at my Channel to see the other compilations! Copyright Disclaimer Under Section 107 of the Copyright Act 1976, allowance is made for "fair use" for purposes such as criticism, comment, news reporting, teaching, scholarship, and research. Fair use is a use permitted by copyright statute that might otherwise be infringing. Non-profit, educational or personal use tips the balance in favor of fair use. THIS VIDEO IS PURELY FAN-MADE!





1992 Ford Mustang 331 Stroker 2010 Dyno run
370hp & 381 ft-lbs SAE 383hp & 395 ft-lbs STD Done at Sanson Ford in Ocean NJ, email me for a 3 pull Dyno run only $120.00 with Air/Fuel and a Video of your run probegtr90@aol.com





Mustang 331 Vortec Supercharged 1/4 mile pass
331 stroker vortec supercharged 11.9 pass




Follow