NHRA Drag Racing Pro Mods & Doorslammers - Mission, BC - June 27/09 part 1 of 4
CanadaMotorSports - Drag racing at Mission Raceway Park, Mission BC, part 1
of 4. June 27, 2009. Check out parts 2, 3 and 4 for more amazing drag
racing including top end 200+ mph passes! Pure Sound! No music, just cars!
NHRA Drag Racing, featuring 8 second door-slammers, pro-mods, pro streets.
Look for Rick DiStefano's beautiful Pro-mod 1953 Chevrolet Corvette.
copyright 2010 AVS Inc
2600hp Ford Falcon??? The DIRTY BIRD
One badass bird! This 1968 Ford Falcon running on 275 Drag Radials lays
down around 2600hp through its 449ci Small Block Ford with a pair of 88mm
turbos, watch it tear down the track at
the North Star Dragaway x275 race.
NZV8TV Ep11 - Ford Falcon GTHO, Nurburgring, drag racing, muscle car racing - part 1
More at http://www.v8.co.nz. Feature Car: Nick Kale's genuine GTHO Phase II
Ford Falcon. This is the real deal with a prestigious racing history, now
restored to perfection.
Andy's back from the 24-hour around Nürburgring, so look out for a full
report from him.
Young Achievers: Speaking of successful racing, we catch up with Anthony
Marsh, as seen in the current issue of NZV8 Magazine, Anthony has been
having huge success at the dragstrip in the Metalman Dragster.
Muscle Car Racing: We caught up with Shane Moore and his ex Super
GT-winning Commodore at Taupo recently, and were amazed with the vehicle.
Shane tells us all about it on this week's show.
Ford Falcon 200 six cylinder engine build
http://www.MyRideisMe.com builds a six cylinder Ford engine, step by step.
With guidance from my pops, a retired Ford mechanic, he shows me how, then
I give it my best shot, not always successful the first time, I hope
everyone interested in building their own engine can learn a little
Blueprint 106 - Cylinder Bore Inspection
We're close to the end of the 100-level series. In this video I show you
how to measure the cylinder bores using 2 different tools. I compare the
results and illustrate what to look for to determine whether or not your
engine is in-spec.
The block I'm using is a 6-bolt turbo
4g63 from early '92. It has 150,000 miles and this video also serves as a
testimony for the durability of Mitsubishi's cast-iron solid-decked Sirius
I engines. This engine will be cut for a new set of pistons, so these
measurements are needed to determine what size pistons I need to get.
.030" is as far overbored as you should ever take a 4g63. Boring larger
than that will take too much off the side clearances between the cylinder
walls and result in compromised strength from hot spots. The only time
you'll ever need to cut a bigger hole is when an imperfection prevents you
from using the pistons you have, or if you're changing to a larger piston.
If you cut the block to its service limit, you have no room to fix an
imperfection should one develop... so it's best to cut as little as you can
get away with. Boring a cylinder .020" over does not significantly
increase its displacement.