Chevy Big Block Camaro 509 "The Grocery Getter"
This is our 80 Camaro
that has been transformed from weak to sick with a 10:1, 509cid solid
roller big block, TH400 with Hughs trans kit, Hughs 3000 stall conv., GM
12 bolt rear with Detroit Tru-Trac and Richmond 3.73 gears all custom built
by me. Frame connectors, and eurothane bushing's throughout stiffened up
the car, Moroso coil springs and Afco rear springs made it all come
together. The fiberglass 4"cowl induction hood keeps it all concealed. We
love the car and cant wait to get it to the 1/4 mile and chassis Dyno to shoot more video's.
Chevy Impala 572 Big Block 750HP!!
Cruisin' in the bad ass Chevy Impala. By www.nelsonracingengines.com
- 572 Big Block Hot Rod series (9,4L)
- 750 HP @ 6000rpm
- Runs on pump gas.
- Richmond 6 speed manual with dual disk clutch and a long shifter.
- 12 bolt 3.55 geared rear end.
- Hotchics suspension.
- Bear 4 wheel disk brakes.
- Custom 2.25 primary pipe on header with dual 3.5 inch Exhaust and dual 3.5 inch 2 chamber Flowmaster
- Engine is carbed with a 1050 street dominator with progressive linkage
and uses MSD ignition.
If you have a nissan skyline or other rice crap, start crying!
Procharger BBC 1st start @ Eric Stubbs' TURBO shop. (E.S.R.)
ADRL XTF racer, Eric Stubbs, of Eric Stubbs Racing fires off the latest BBC
Procharged project that he has done the fab work for and will be doing the
ERIC is on the initial phase of gathering data and getting this baby tuned
up enough to go and gather some Track Data. This blower is almost as large
as the BBC engine. The 2010 track data is coming soon. More VIDS to come.
E.S.R. is the PLACE to BE if you are building a ProCharged or turbocharged Street OR Race Car. ESR is near
Houston,Tx @ 281.468.1805.
How to install or change or replace gears and bearings in a rear end or differential
Installation of carrier bearings, pinion bearings, ring and pinion and a
crush sleeve are covered in this video. The main tricks given in the video
are about the actual set up bearings. The rear end being worked on is a
8.5 inch gm 10 bolt out of a second generation f body. Tooth contact
pattern charts are available on the internet, do your own research.
BIG BLOCK CHEVY on 54" BOGGERS BREAKS REAR END - FIRST HOLE RIVER RUN!!
Brian (TheMudBogger79) takes the first hole at River Run near Jacksonville,
TX. Pinion bearings were going out on rear 2 1/2 Rockwell axle, which
caused the pinion to shear. He removed the rear driveshaft and drove the
rest of the day.
Silverado details - 505 chevy stroker big block , solid lift cam , forged
crank rods and pistons , cast iron heads with port work , roller rockers ,
10.3 -1 compression.
Be sure to check us out on Facebook at Triple-X Motorsports & Outdoors for
all the latest updates!
#8 - Most Discussed (Today) - Autos & Vehicles
#105 - Most Viewed (Today) - Autos & Vehicles - Canada
#40 - Top Favorited (Today) - Autos & Vehicles
#14 - Top Rated (Today) - Autos & Vehicles
#67 - Most Discussed (This Week) - Autos & Vehicles
#71 - Top Rated (This Week) - Autos & Vehicles