Burnouts open headers on the street
I am the announcer at Kansas City International Raceway.KCIR. This video
was taken June 3rd. 2006 on a very busy 4 lane road that was just
resurfaced and repainted, i think they did it just for me and a couple of
hundred of my friends.It was called an open header cruise, where cars would
cruise to Fuddruckers about 5 miles from the dragstrip. Then with the help
of some friends we shut down the road for about 20 minutes until the police
My Pro Street v8 S10
Everything is almost brand new!
1988 S10 ( GMC front grill )
Painted to match.
Full Roll cage
New Edelbrock Air Gap Intake
Cast Heads 202/1.60 Heads
Keith Black Hypereutectic Pistons
Meilling High Volume Oil Pump
Scat 3.48" stroke cast crankshaft
Scat 5.7" I-beam rods
Hardened Push Rods
Magnum Roller Tip Rockers 1.6 Ratio
.501 Lift Cam
CVR Electric Water Pump
corvette alloy radiator
dual electric fans
holley Blue Fuel Pump w/regulator
16 gal fuel cell
All Steal Braided Lines
Complete Painless Wiring harness
MSD 6A Ignition Box
MSD Coil Distributer
Flomaster Exhaustturbo 350 With 3000 Stall Converter (
Line Lock )
Tubbed 4-link rearend
3:42 rearend W / Moser Axles
fenders flared out
18" Torque Trust rims ( deep dish in rears)
lowered 5" all around
all brand new suspension tie,rods,end links,ball joints,
4-link seat belts on 1999 dodge viper leather bucket seats
full Auto-meter Gauges,oil,temp,volt,fuel,speedo,shift light
Brand new Headliner, Carpet
Bad ass v8 s10
New cam, rings, seals, bored 60 over, new headers......Not bad for an
Arkansas shade-tree truck!!!
S10 V8 BURNOUT!!!
1986 S-10 w/ 350 Burnout 1st, 2nd, and 3rd Gear! Car coming down road
drives through smoke! MUST SEE!!!
~*~TRUCK FOR SALE~*~ (Northern Indiana)
93 s10 383 SBC Open Headers
Breaking in the s10 after tuning up the 383 stroker.
Dart Pro 1 heads, extreme energy roller cam, 6"rods, pro magnum rockers....
Fast S10 With Stock Suspension
Test run. This is on 28 x 10.5 tires, stock suspension & stock frame
rails, small block 352 chev, one carb and at 3115 pounds. In 1/4 mile it
will run mid 8's.
s10 with headers and no exhaust revs
i had just finished putting the headers on my truck so i try it out for the
first time. no mufflers or anything by the way so its really loud. i have a
1993 s10 SS with a 5 speed and the 173 2.8 v6
Prostreet v8 s10 IDLE / REV UP!
Just video showing a friend Will the idle and rev ups, i reved up to only
4500-ish and you can hear the gear drive slightly.
built s10 v6
The first start up of my new fully built moter that has took me a couple
months to finsh runnin it with open headers.
I cant rember the cam specs its a tow&haul cam. rpm range is 1500-4500