Mazda rx3 coupe
74 rx3 coupe 12app injected first run on new injection setup after Dyno , just got a wof, running
Pac Performance Rx2 Coupe (GOD RX2) Powercruise 1day Powerplay 3-11-12
only on set two street Boost, pump
fuel, drive there & drive home piloted by the man himself Dom perri, makes
over 400hp ATW on pump fuel, with a best ET of 9.6 on its old setup.
car was built and tuned by the boys at pac performance.
its yet to hit the track with its new setup, looking for an 8 second pass
in the future.
Mazda RX3 Gundam
My RX3 was restored by PUI Rotary in Bangkok Thailand with Weber IDA 48
Bridgeport 12A Rotary Engine, Watanabe rims 14"x10" AND 11"
Mazda RX3 tags the wall - MRHELI
King of the 2-step, Frank 'Mr Heli' Canistra hasn't raced the RX3 in some 2
years. The 13B rotary turbo powered
Mazda sedan ran strong all day going into the low 8s but got loose late in
the night. Frank did a great job of steering out of what could have been a
heavier hit and the good news is that he walked away unhurt.
APSA Pro Street Shootout round 3, Sydney Dragway, Australia - May 18th
RX3 crash - The Godfather
Sam Sadek was very lucky to walk away from this big accident at close to
200mph. The PAC Performance Godfather Mazda RX3 is powered by a 20B turbo rotary engine.
APSA Pro Street Shootout, Sydney Dragway - May 18th 2013.
1974 Mazda RX-3 /Walter Mitty
This was a practice session at Road Atlanta 2013 / Walter Mitty/HSR.
I'am driving Gordon Zadie"s 1974 RX-3 Tube chassis GT-3 road race car.
12a bridge port with 40 mm chokes in the carb.
Car weight 2030 with driver.
The Zero F**ks Given RX7 - /TUNED
Would you drive a car built by a teenager in his parents driveway with no
safety features whatsoever? We did, and now we'll tell you why this ugly
RX7 is so brilliant.
Part 12: 13B Rotary Engine Rebuild - My 76 Mazda RX-5 Cosmo Restoration
Just as I promised last episode, it is finally time to build the engine!
Part 12 of my RX-5 Cosmo restoration covers the entire process of building
the 6 port 13B Mazda rotary engine. While this engine is a hybrid of GSL-SE
RX-7 and Cosmo parts, the process is the same for any rotary from a 12A to
a 13B NA, 13B turbo, 13B-REW or any
other variant of the 13B. This video shows the whole process of the engine
build, starting from measuring the rotors and covering everything else
including clearancing the side seals, assembling the rotors, complete
assembly the short block, setting the eccentric shaft end play and
installing the front cover and everything underneath it. It's probably the
most complete engine build video outside of what you can buy from the
vendors, and as such, is an hour long. After this one, I'm going back to
videos under 20 minutes. But for now, grab a beverage of your choice, sit
back, and enjoy.
What its like owning a 3 Rotor 20B RX-7
I have one of the most amazing custom RX-7s in the world. I want to share
my experience of owning and driving such a unique car.
I explain where the engine came from, why its so special, and what it does
to a Mazda RX-7