Drag Racing 1/4 Mile times 0-60 Dyno Fast Cars Muscle Cars

Using the 3M Stripe Off Wheel (eraser wheel) 2007.5 Chevrolet 2500HD Silverado Lifted on Cognito

Removing the molding off the LMM. 2007.5 CHEVROLET 2500HD COGNITO 10"-12" LIFT NTBD (Non-Torsion BarDrop) Set at 10" DEAVER 8" REAR LIFT SPRINGS 17"x9" XD SERIES "REVOLVER" in Bronze 37" x 13.5" SUPER SWAMPER-M16s BILSTEIN 5100s COGNITO STEERING BRACES COGNITO HD TIE RODS 5" MBRP Exhaust w/ RBP 6" TIPPY QUADZILLA STEALTH2 TUNER N-FAB NERF STEPS http://www.norcaltruck.com/ http://www.zirogear.com/


 


More Videos...


How to DE-BADGE / Remove molding from a vehicle
http://www.gofasthavefun.ca In this video we show you how to easily remove body side molding or badges from your vehicle and make sure you don't damage the paint. Tools and materials needed: Heat Gun Fishing Line Cleaner (All Purpose or WD-40) Polishing Compounds Go Fast have Fun Canada





How To Remove Car/Truck Emblems with the Eraser Wheel
Here is am removing the door spears off my Dodge Ram. I got a lot of questions when I did the emblems. So I figured I'd throw a quick video up on how I did it. Here you can see I used the Eraser wheel and 17lb fishing line. Pretty much it. I used the fishing line to "CUT" them emblem glue/adhesive from the emblem.. remove the emblem and then used a Eraser wheel to remove the adhesive left behind. Since my truck was a 2007.. it wasn't easy to remove with hand. Some newer cars you can do it with just your fingers. IF your car is older - it has had time to bake to the paint. Worried about ghosting? It will go away real soon. Waxing helps afterward and even some acetone if you have glue left over.





How to Pinstripe a Car
A quick lesson on pinstriping





Car Damage Repair (Part 1)
Comments REQUIRE APPROVAL. THINK before posting. NOTE: I am NOT a Car Care Expert, nor claim to be. NOTE: This is =NOT= a Tutorial on how to repair a vehicle. It is a progress series. The Epic Tale, of fixing a car, after some dunce taxi driver hits it. Fortunately, the bumper, PHYSICALLY, is 100% undamaged! Cosmetically, it was a total mess. Before I started this video, I got half the "Darlington Stripes" off if it, and in this segment, I remove the rest of them. Some scratches remain, and there's some chipped off paint. Tocuh-up painting is in the next part. BEFORE SOMEONE SAYS IT: No, I do NOT have the time, or money, to go though the hassles of insurace companies, getting it appraised, quoted, and replacing the bumper. The damage is fairly neglegable, and when it's done, it'll not be perfect, but will look like other parts of the car. ALSO: Once all is done, the receipts for the materials will be sent to the cab company who was responsible. Fortunately, it's not going to be a major nightmare.





Removing Vinyl Graphics and Adhesive rapidtac.com
Roger demonstrates just how easy it is to remove Vinyl Graphics from the side of a Hummer H2 with the right tools and Rapid Remover Adhesive Remover





Wheel Stripe Sticker Decal Installation
Get custom made wheel stripe stickers at http://www.stickercity.com/custom_wheel_stripe_sticker_decal.html





How to remove pin stripes from a car by Tom Bugby
A step by step video on how to remove pin stripes from a car using a 3M pin stripe removal wheel by Tom Bugby: How To's with a Sense of Humor.





Snow Foam Clean
http://www.youtube.com/watch?v=RE13SLsjUaY





Installing Premium 2-mil Vinyl Graphics on Mustang GT Part 2
Wet application of premium cast 2-mil vinyl onto a Mustang GT





RV black streak remover/wax
Give this a try it works great!





Taking vinyl racing stripes off (1997 Grand Prix GT)
I changed the title so it was clear that I was taking the stripes off. :)





3M Di-Noc Carbon Fiber Vinyl Racing Stripe Installation
Get 3D Carbon Fiber Vinyl Wrap Sheets at http://www.stickercity.com/carbon-fiber/





DIY: Vehicle Badging Removal/Replacement
Vidoe tutorial on how to remove/shave your vehicles emblems/badges. I have also included how to add a new emblem to a vehicle. This particular procedure was done on a 2004 Volkswagen Golf TDI. Tools needed are a heat gun or hair dryer, dental floss or fishing line, polisher is optional, polishing compound, wax, lint free polishing cloth, brake cleaner or rubbing alcohol, ruler or string, and a fine tip marker. Now not all vehicles have smooth glue on emblems, some types have alignment holes in the backside which would need to be filled afterwards. For a full polishing tutorial, view this video: http://www.youtube.com/watch?v=6kdhxWB2nMw Procedure: -using a heat gun, heat the area of the emblem -once warm, take the dental floss and run it against the body around the emblem to cut away the glue -once half was through the emblem, you can assist pulling it back with your hand -once off, some of the remaining glue can be cleaned off by rolling it on the body with your fingers -wipe away the left over glue with a form of degreaser -there will be an outline of the old emblem, the paint can be polished to remove this -if you are reinstalling the emblem, use reference points to determine where it can be places and to ensure it is level on the vehicle -wipe the area down with a degreaser to ensure it won't affect the adhesion of the new emblem -place on panel and firmly push to ensure it is adhered to the panel Thank you to all those who watch my videos and support my content. Don't forget to subscribe to my channel for future tutorial videos and like my video if you found it helpful. New videos are always being uploaded every week! Please LIKE my Facebook page @ http://www.facebook.com/pages/4Diyers/106898752724865 or FOLLOW me on Twitter @ https://twitter.com/4DIYers © 4DIYers 2013 All Rights Reserved No part of this video or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author.





Blacked Out Emblems with Plasti Dip
This product is awesome. It's not permanent, so you can mess up as much as you want. It's easy to apply. It's easy to remove. Try it on anything, if you don't like it just peel it off. I blacked out my emblems on my Nissan 370z. It looks really good if you want the "blacked out" look. Keep in mind that I was filming this with one hand and using my other hand to peel off the Plasti Dip, so I apologize for all the grunting and stuff. No homo. Common Answer #1: You will need approximately 3 cans to spray all four wheels using 4 coats on each wheel. Common Answer #2: You can buy Plasti Dip at Home Depot, Lowes, and OSH. Common Answer #3: Yes, it's safe to drive through the car wash and pressure wash over the Plasti Dip, but I wouldn't recommend it. Common Answer #4: It's not necessary to spray the inner wheel wells. I just sprayed the face of the wheel. Common Answer #5: The newspaper masking was to prevent over spray and makes cleaning up easier and quicker. Lastly, I made this video to show the car enthusiast community, who are interested in blacking out their emblems, a much easier way to do so without removing the emblem and painting it or buying a whole new black emblem. Plasti Dip can result in different textures depending on the outside temperature and how close/far you spray. Try it and see what works best for your specific application. Watch in 1080p for best viewing pleasure.





How to paint a Car at home yourself! All Car Painting steps one video!
See all the car painting steps from how to repair a body panel to prepare the surface and to paint a damaged panel on a car in one video. For anybody who's wanting more detailed info on how to paint a car, here is a great source --- http://88d8f9-gixyu5sdeumcv0zq81t.hop.clickbank.net/ If you are looking to get your own car painted and you need to do the job yourself on the very "cheap" then learning the step by step and painting it yourself at home is the only way to go! Keep in mind, that there are multiple ways to accomplish each task that you are about to embark on. The information included here is "SIMPLIFIED" but does get the job done, there are other techniques and the process that may produce slightly better results(blending, spot painting with blend) but this is the information that I felt best for beginners.... For more info and help from like minded individuals go here! http://88d8f9-gixyu5sdeumcv0zq81t.hop.clickbank.net/ Have fun and DIY....




Which car is faster? Which Car is Faster?





Similar 1/4 mile timeslips to browse:

2007 Mazda 5 GS: 17.300 @ 77.491
Roan,


 


©2014 DragTimes - Disclaimer