Drag Racing 1/4 Mile times 0-60 Dyno Fast Cars Muscle Cars

How To Properly SeaFoam A Subaru EJ251 Motor

Go through the EGR valve on the top of the plenum.


 


More Videos...


Remove Carbon Deposits from Subaru Sti using Sea Foam
Sea Foam to clean carbon deposits in your engine





HOW TO SEAFOAM YOUR VEHICLE. STEP BY STEP GUIDE (Geo Metro Seafoam Part 1)
A step by step guide on HOW TO USE Seafoam on a vehicle. Enjoy!





Sea foam engine cleaner in a Subaru WRX
A friend of mine asked me to tape him putting Sea Foam engine cleaner in his 2004 Subaru WRX. I had to laugh because a neighbour walked over to ask if he blew his turbo! Lot's of smoke that's for sure!





Subaru Forester EJ20 Engine
Showing how to remove the Idle Air Control Valve, cleaning and testing it and also cleaning the housing that it sits in on a 2001 Subaru Forester EJ20 Engine 2000cc





Seafoam in a WRX
This is a cleanout of my engine with seafoam. Great smokeshow. Seemed a lil bit peppier as per the buttDyno. Also did this to a friends forrester today *sorry no vid* but that helped ALOT





How to change a Subaru Head Gasket without removing the engine
These are the sets I like to use on these EJ25 engines. http://www.amazon.com/gp/product/B000C2AISU/ref=as_li_qf_sp_asin_il_tl?ie=U TF8&camp=1789&creative=9325&creativeASIN=B000C2AISU&linkCode=as2&tag=httpww wyou00f-20 1:07 Identifying engine type 1:25 Inspection showing oil leak from head gasket 3:12 Remove air intake (discussed) 3:35 Remove battery (discussed) 4:00 Remove air compressor (discussed) 4:10 With above removed and belt covers removed 4:20 Remove belts 5:49 Remove A/C compressor tensioner bracker 7:00 Remove alternator 8:50 Remove air compressor (discussed) 8:56 Drain radiator 10:10 Remove power brake Booster vacuum line, fuel lines 11:48 Disconnect spark plug wires/brackets 13:42 Remove A/C compressor 14:15 Remove spark plugs/bracket 15:02 Disconnect oil sending unit wire, coolant temp sending unit, crack shaft position sensor wire 15:50 Remove radiator´╗┐ How to change a Subaru Head Gasket without removing the engine





Subaru Owner Tips: Timing Belt Idlers
Recorded At All Wheel Drive Auto: Independent Subaru Repair in Kirkland Washington 98033 www.allwheeldriveauto.com





How to replace a SOHC Subaru 2.5l Timing Belt
Get a new tensioner here: http://www.amazon.com/gp/product/B00BGBV8YY/ref=as_li_qf_sp_asin_il_tl?ie=U TF8&camp=1789&creative=9325&creativeASIN=B00BGBV8YY&linkCode=as2&tag=httpww wyou00f-20 How to replace a SOHC Subaru 2.5l Timing Belt





Subaru Legacy SeaFoam Tutorial
-Just a video of me sea foaming my car.





How-To - Change Automatic Transmission Fluid & Filter for Subarus
This video shows you how to change the automatic transmission fluid and filter for most newer Subarus. Some minor differences with the older cars is that they may not have the spin on filter similar to an oil filter. Tools required: Drain Pan 17mm Wrench or socket driver Transmission Funnel or similar Paper Towels or rags (optional) Empty Engine oil container (optional)





Learn About Subaru Boxer Engine Technology
The Boxer Engine is a Subaru Core Technology. Learn about its benefits and advantages. Web: http://www.newroads.ca/blog/tag/subaru-technology/ Visit us online: http://www.newroads.ca/subaru Twitter: https://twitter.com/SubaruRH Facebook: https://www.facebook.com/RichmondHillSubaru Pinterest: http://pinterest.com/richhillsubaru/ Stop in and say hi at 11645 Yonge St., Richmond Hill, Ontario Toll Free: 1.888.306.4960





How To Seafoam Your Vehicle
2 Can of Seafoam & 1 Can of Deep Creep - 1 can goes into your fuel tank and half of the other one goes into your oil and the other half goes through the brake Booster line. The Deep Creep is sprayed through the throttle body. Let the vehicle sit 15-20 mins. and start up and watch the smoke show. If you have no smoke your vehicle didn't have any carbon build up to clean off.





How to SeaFoam - Subaru Impreza WRX
A simple procedure of SeaFoaming an engine in a Subaru Impreza WRX.





2000 Subaru Outback - EJ251 Valve Cover Gasket Replacement
2000 Subaru Legacy Outback valve cover gasket removal and installation. Took approx 3 hours, including a spark plug change. Procedures: Passenger Side- Remove air duct and resonators. Remove spark plug cables. Remove valve cover and all old gaskets. Clean valve cover and re-install with all new gaskets. Driver Side - Remove battery Remove Washer fluid reservoir. Remove oil reservoir. Remove valve cover and all old gaskets. Clean valve cover and re-install with all new gaskets. Install everything else in reverse order. Note: Torque is 3.6 ft lbs so be wary of over tightening. Need a 10mm wrench to get into tight spots, ratchet is too big.





Dumb Things NOT To Do To Your Car
Scotty Kilmer, mechanic for the last 46 years, shows some of the dumb things he's seen people do to their cars. And, If you like my car help, be sure to watch my live car talk show every Saturday morning at 10 AM CST on YouTube. I answer your car questions LIVE there. Just check it out at https://www.youtube.com/watch?v=VognjkYaMjg&list=UUuxpxCCevIlF-k-K5YU8XPA&f eature=c4-overview . And remember, every TUESDAY I upload a new video, so don't miss them.




Which car is faster? Which Car is Faster?





Similar 1/4 mile timeslips to browse:

1977 Volkswagen Polo Typ 86: 9.617 @ 147.060
Boba, Engine: VW 1,8L 16V KR, Turbos: Garrett GT4094R Tires: M/T 28x10.5-15


2006 Volkswagen Polo 9n2 GTI: 14.370 @ 99.000
Jason Smith, Engine: 1.8T 20Valve, Turbos: K03S Tires: Nexxen 205/40


2005 Buick LaCrosse cxs: 15.585 @ 89.630
Matt D,


2005 Buick LaCrosse CXS: 15.800 @ 90.700
NA,


2010 Buick LaCrosse CXS: 15.810 @ 90.310
NA, Engine: V6: 280HP,


1994 Ford Aspire : 18.741 @ 69.550
Anthony Easley,


1995 Ford Aspire 2 dr.: 18.903 @ 68.530
Ryan Kerr, Engine: stock 1.3 home made intake, Supercharger: none Turbos: none Tires: stock


1995 Ford Aspire 2dr: 19.028 @ 69.920
Ron Huntley, Jr.,


 


©2014 DragTimes - Disclaimer