Cutting White Wire on Saturn Ion to Fix Starting Issue
This is me showing how I cut the passlock wire on my car. My car would not
start on damp, cold mornings, often taking 30 - 40 minutes to get it to
start. After reading several forums I found users who were doing this to
"fix" the problem. I thought I would tape this for anyone who was thinking
of doing the same but doesn't know anything about cars. Like me. :)
Note: I owe thanks to meron for the post at this link
http://townhall-talk.edmunds.com/direct/view/.f1137a7/83 it is where I
first heard about this solution.
Update 10.6.2012: I added a switch, I believe it was this one
http://www.radioshack.com/product/index.jsp?productId=2062533 I installed
it with it in the off position, started the car, switched it to On while
the car was running and the service engine light went away. Car started
fine after that. I just shut it off again as it was cold one morning this
week and I had trouble getting the car started. Once I got it running,
turned it off and haven't had trouble starting it since. YMMV
Transmission Fluid Replacement 2002--2007 Saturn Vue
If you have any questions please visit
http://www.2carpros.com/questions/new where we will answer any questions
you might have.
Please use all safety precautions.
Saturn Idle problem.mov
In this video we show you how to replace an idle air control solenoid and
clean the throttle body on a 1996 Saturn. This car was having a
excessively high idle. It would stay at 1500 RPM even though your foot was
not on the gas pedal. This was caused by carbon build up around and behind
the throttle body as well as a defective idle air control solenoid.
Jonesy's Auto Club videos are for reference and entertainment only and
should not be taken as a direct step by step guides. If you attempt a
repair like the one seen in this video please use the proper safety
equipment, take your time and do the job right.
How to change the oil in a saturn.
* * * PLEASE READ * * *
In this video I show how to drain and refill the engine oil as well as
replace the engine oil filter.
The car in the video is a 2007 ion with a 2.2L inline 4-cylinder engine.
The engine holds 5 quarts of oil.
The owners manual recommends a torque of no more than 18ft.-lbs to hold the
filter in place.
The owners manual also says to reset the oil life meter after an oil change
by first turning the key to the on position. Then, press the button on the
trip meter until it reads 'oil life'. Hold the button until it beeps 5
times. That should reset it.
I am not responsible for anything.
For more visit krkvideos.mezoka.com
06 ION Redline vs 09 Cobalt SS/TC
ION Redline mods: CTI Full Exhaust,
80# Fuel Injectors, E85, M62 w/ Ported outlet/Polished inlet, 2.6" Pulley,
HPTuners Custom Tune, B&M Short Throw Shifter, K&N Drop In Filter, ZZP S3
Heat Exchanger, Dual Pass Endplate, GM Option B Kit
Cobalt SS/TV mods: GM Stage 1, Hahn 3" cat-back, K&N Drop in Filter
Its a 2009 Cobalt SS/TC. Here is a link with more information about the
So can you guys stop your whinnying?