McLaren MP4-12C 650S How to completely disable ESC traction control systems
Shows how to completely disable the traction control systems on the McLaren
MP4-12C and 650S. Video also includes a teaser for the tuned vs stock
Car at operating temperature
Active Panel Off
Suspension and Transmission switches in track setting
Hold down active button for 5 seconds
Message will appear on left screen asking to confirm ESC Off
Hold down Aero and Manual buttons for 5 seconds
Message appears stating the ESC is OFF.
Saturn 1991-1999 1.9L Clutch Hydraulic System
We're replacing the clutch master and slave cylinder on a 1999 Saturn. 1st
we remove and replace the master and slave cylinder then I show a prefilled
clutch hydraulic release system to service this Saturn with.
saturn vue cvt part 1
In this video, I am going to show how to disassemble and repair a Saturn
Vue / Ion CVT Transmission.
Saturn SL2 Valve Cover Gasket Replacement (DOHC)
This is a long one, Sorry, but it pretty much goes through the step by step
and shows some of my mistakes so you don't make them.
Also, verify that the gasket fits. If you have the time then I would
suggest bringing the valve cover in with you(assuming you bought it from a
local parts store) and make sure it fits before leaving. I must have gotten
one from a bad batch because the first one was too big. You will see that
in the video. The second try was the right(ish) one. apparently it is a
known problem that the molding process is incorrect for these gaskets but
luckily they are rubber so you can just remold it to fit.
Also a word of caution: at some point you may see me use carburetor cleaner
on the plastic valve cover. DO NOT use carburetor cleaner on the plastic.
The main ingredient is Acetone(which I also use to clean) and it has the
ability to melt the plastic. Use another solvent that is friendly to
plastics like mineral spirits.
Good Luck and Hope this helps you save some money. Spent about $60 total
doing this in tools and parts.
Note: I am not a mechanic, these videos are meant to be for informational
purposes only. Should you follow the steps shown you do so at your own
Pimped Out Saturn SL2 *UPDATED*
NEW: just got a body kit! its installed but has a few fitment issues that
need figured out. looks sweet, but needs some work before its done!
also did the "Flip Flop" trunk mod, took out some of the carpet, cleaned
things up. always messin around with this thing
check out my page: http://www.cardomain.com/id/courtlife
*NEW 18" Konig Uknowns with Kumho spt tires (for the summer)
*removed the bar across the "grill" and the front license plate - looks
*swapped the subs and Tv's because of trunk rattle & tailgating purposes
*Redone carpet in the trunk/back of the back seats
*Black Saturn Emblem
*Sony Door Speakers
*Saturn Racing Team decal on windshield
*Painted Calipers and Drums black
*Repainted the dash Silver
*Painted the molding above the windows black
*Weapon-R cold air intake
*Chrome Exhaust tip
*Switches installed on dash for Amp and power inverter for PS2 & tv's
*2 12 inch Type R
*Q-Logic Ported/Sealed Box
*2 15 inch Sony TV's
*Power Acoustic PTID-6500
*150 Watt PA System (Speaker is OUTSIDE)
*Blacked-Out Taillights and Side markers
*Sony Playstation 2 in the trunk
*5 % tint
*Bulldog 200 Deluxe Remote Start
All installation was done by myself, including remote start and tint job.
Any questions or comments are appreciated!