1970 Chevelle w/ Open Headers
Chevelle w/ a 454 BBC, open Headers, on stone cold start up. It starts to idle normal about the 2:00 mark. No choke as its a race carb.
Big Cam Big Block Camaro Loud Mufflers 4" Exhaust
This is a older video of a friends Camaro. It's a 477ci engine with what sounds like a huge camshaft. This car has a four inch Exhaust system with moroso race mufflers and a crossover pipe. It's very loud and has run in the 6.50s in the ieghth mile. The old white Chevy truck in the background is the starting point for the 505 first start video I have on here.
How Flowmaster Mufflers Work
Flowmaster demonstrates how its straight-through and chambered mufflers work. This video includes animated illustrations to show the sound-deadening principles behind its chambered (baffled) mufflers with delta design as well as its glasspack (straight-through) Exhaust mufflers. http://www.summitracing.com/redirect?banner=SocialYT449
Pontiac running 2009 big cam idle
1964 Pontiac Tempest, 2dr Post, 455 .040 over, 4X heads, Comp XE274 cam,Performer RPM manifold w/ Edelbrock Performer 800cfm, Full Pypes X Exhaust with RacePro mufflers.
Engine has Holley 3130/750 now and different timing set up. Made huge difference. I could never get the Edelbrock carb to work right. And yes the Mr Gasket header gasket on the driver side was leaking just 40 minutes after break in.
monte w/ AFR headed full roller 383_1
85 m/c 383 stroker w/ AFR heads, full roller cam, etc, etc, etc........ first time pullin it out of the garage after the build. Thanks to Paul at Accu pro race engines for building me one nasty 383!!
1977 Trans Am - Pypes Race Pro Exhaust
1977 Trans Am W72 (400, four speed). Just installed a new Pypes Exhaust - 2.5", x-pipe, transverse Race Pro muffler.
Pardon the dirt and grime - due for a detailing.
'70 chevelle dyno
'70 chevelle with 555 ci big block. 11:1 pump gas engine with a big solid roller, AFR 335's, vic jr., pro-systems HP1000 carb, 2" headers, 3" collectors, full 3" duals with x pipe running Pypes Race Pro mufflers. Electric cutouts are installed and are CLOSED for first run, OPEN on last run.
Car has a TKO600 trans and 12 bolt rear end in this video. GForce GF5R and Dana60 are going in this winter.
Engine made 792hp/701tq at the flywheel on a superflow engine Dyno. Chassis Dyno showed 618rwhp AT 5500 ONLY - data did not log up to the 6800 it was run to due to a Dyno error. Based on the 70hp increase from 5500 to 6800 rpm on the engine Dyno (horsepower peaks at 6800rpm), we are guessing we have around 670-690hp at the wheels.
Car will be back on the Dyno in the spring. Engine built by Mike Lewis of Lewis Racing Engines, Laytonville, CA.
How to repack DRD Exhaust / Muffler
This video created by Duback Racing Develepment shows how to repack one of theirs Exhaust sytems.
DRD official website - http://www.dubachracing.com
Sound Testing: Flowmasters 8 Hottest Mufflers
We test 8 of Flowmasters most popular mufflers for street cars to muscle cars to full blown race cars! From mild to aggressive, find out which muffler is right for your car and get that classic Flowmaster sound.
Pypes Race Pro 3in. muffler, TBI Silverado
Stocker 350, for now... Just a Pypes Race Pro 3in in 3in out stepped to 2.5 90 degree. Before it was resonating real bad b/c I had in ending at the end of the muffler and the bed was just a resonator box, so I just got pep boys 90 degree and turndown and it is a completly different truck. I cannot hear/feel ANY resonance in the cab, at any speeds. I dont really like how quiet it is on the inside but it really does sound damn good on the outside. Also the Race pro flows like 680 CFM so its a zero loss muffler for me at least, I will try and post with a better camera, its just an easyshare C180
