Drag Racing 1/4 Mile times 0-60 Dyno Fast Cars Muscle Cars

gdo led sirena gyroled police gyrophare

comparaison entre le gdo LED et HALOGENE


 


More Videos...


T4 Surface Module Wiring Demo by CPS Authority Emergency Warning Lights
CPS Authority Product Link - http://www.cpsauthority.com/index.php?main_page=product_info&cPath=4&produc ts_id=105 Here is a great video to show the wiring and sync abilities of the T4 surface module light head.





Federal Signal Navigator lightbar Flash Patterns with Optional White Light
Product Webpage: http://fedsig.com/products/376/navigator_lightbar Navigator™, a linear, high-profile LED lightbar, that offers first responders an unique choice of using LED reflectors and LED rotators in one platform. Designed to fit the needs of multiple agencies, the Navigator’s options and overall flexibility can be used in fire apparatus and command/fleet vehicles.





240 Amber LED Mini Strobe Light Bar
www.hk5motors.com Only requires a cigarette lighter to install. Bottom of the bar have magnets to easily post on top of the vehicle 7 Modes of strobe with just a push of a buttom





Maxxima LED Strip Lighting for Police and Emergency Vehicles - DAYTIME VIDEO
This is for comparison only, the Maxxima LED strip lighting are those picture in the lower front grills, below the car (front, sides, and rear), and the LED strips on the rear glass of the car. The video shows the car without the lights on first. I had reviewed several videos, all of which showed the lights at night time. This was taken in full sunlight. I cannot give these lights anything but 5 stars! They are actually brighter than what appears in the video. I will later be posting a video taken a dusk side x side with a vehicle that has the HG2's for comparison. I hope this helps you out! I will also post a video of my car at night (man it looks good...) Just search for Maxxima LED Strip Lighting for Police and Emergency vehicles NIGHT or DUSK video. I purchased the lights from Vehicle Lighting HQ. They were very helpful to me. I initially looked at the HG2 Runner lights for the side of my car and couldn't afford them (although they are very nice). I did all the LED lights on my car for under $400 (the HG2's were going to cost $800 installed at the dealer for just the side runner lights). I obviously had to do the installation myself, which saved $$ and allowed me to install A LOT of additional lights! Hope you enjoyed the video!





Police/Undercover POV Vehicle LED Warning Lights Impressive Setup on 2011 Toyota Tacoma
Blue and Red LED Emergency Lights installed on 2011 Toyota Tacoma pick up truck, these lights are placed on the vehicle's grille, windshield, dash, side view mirrors, fog lights, headlights, and rear deck. http://www.online-led-store.com





BRITAX - DELIVERY (code3 premier hazard)
livraison de 15 rampes Britax dont prototypes- code 3 - Premier HAZARD : ULTIMAX, MX7000, LP6000, LOMAX, MAXIM EXCALIBUR





Coordinated Emergency Lighting System from Code 3
Imagine taking the programmability of a lightbar and applying it to all of the emergency vehicle lighting. Introducing the CELS system from Code 3.





Police Nationale | véhicule banalisé officier
Châssis Ford Mondeo, véhicule banalisé du chef de la police de Charleville-Mézières. Gyrophare GDO sur le tableau de bord. Vidéo full HD. Plus de photos sur spotting.web.free.fr





Voitures banalisées Police Nationale Paris (compilation)
by Dirk Steinhardt - http://www.rescue911.de - Paris, Ile-de-France, France - 03 2009





LAMPHUS® SolarBlast™ 36" 32W LED Traffic Advisor Emergency Vehicle Strobe Warning Lightbar Part II
http://www.online-led-store.com This LAMPHUS® SolarBlast™ SBTA84 36" 32W LED Emergency Vehicle Strobe Warning Lightbar with Traffic Advising Functions is composed of eight high intensity LED light blocks for an intensely bright warning signal. This unit comes complete with a Quick Directional Controller which can advance the unit to one of its three directional flash patterns with a press of a button (Left, Right, or Center Out). With 19 selectable flash patterns and being suitable to be mounted to vehicle of all sizes, this versatile strobe light unit will grant emergency personnel with the ability to alert oncoming automobiles with the correct flow of traffic. For any inquiries, please email us at support@online-led-store.com





Les nouveaux VSAV Full LED du BMPM
Véhicule Mercedes Full LED du Bataillon de Marin Pompier de Marseille, très visible de nuit et même le jour ou le flash des LED illumine le véhicule malgré le soleil (Ce que ne reflète pas trop mon caméscope) ! Arrivés cet été 2010, boite automatique, clignotant sur rétroviseur ! Filmé face à l'hôpital de la TIMONE, Marseille dans le 5ém. En espérant que cela ce généralise pour tous les VSAV et véhicules de secours en France ! Merci pour les photos à PASCAL CHEVASSU : www.netpompiers.fr Pour plus d'info : http://www.forum-pompier.com/sujet31064.html Et bien sur : http://www.marinspompiersdemarseille.com





test rapide RAMPES BRITAX
Test rapide, sans plonger dans les câbles et les options, ce qui explique certains dysfonctionnement lumineux.





Police Motorcade Escort Banque de France Scania Trucks: COTEP Gendarmes BMW Motorcycles
Two Scania 124L 420 trucks transfering money for the Banque de France are flanked by six (6) Citroen C8 cars of the "Gendarmes Mobiles" plus la COTEP Police Nationale car and four (4) BMW motorcycles. Paris, France. 10.2010 Remarquez que les Scanias ont des LEDs maintenant, à l'avant ainsi que sur les côtés avant et arrière. Deux lumières stroboscopiques sont toujours pourtant sur les toits des camions. Les Peugeots 605 blindées sont parties et des Citroens C8 sont désormais sur scène. Voir mes anciennes vidéos avec des camions Scanias précédents et des Peugeots 605 blindées. Utilisation rare du système "public adress".





Sirene americaine SAMU
vidéo prise sur le vif, désolé pour la qualité !





HL6 Grille and Surface Mount LED Emergency Vehicle Light
http://www.911signalusa.com/hl6-hornet-led-lighthead-p-50.html In this video, viewers can watch as Mike, our personal emergency vehicle lighting installation expert, installs HL6 Grille and Surface Mount LED Emergency Vehicle Lights on our 2013 Dodge Charger demo vehicle. Mike has chosen to install the grille lights, which are popular police lights, around the license plate of the Charger. Doing this helps illuminate the rear of the vehicle, which can be influential in reducing the risk of rear-end collisions. Step 1: Mike Drills Holes around the License Plate As you can see in the video, Mike drills one hole on each side of the license plate for the grille lights. Before, our installer drilled the holes, he checked to make sure the holes were even. This is a critical step because once you have drilled the holes, it can be nearly impossible to start over. Step 2: Begin Feeding the Wire through the Holes Once the holes are drilled and Mike is sure the holes are even, he begins feeding the HL6 wire through the holes and checks the placement of the lights on the Charger. Step 3: Preparing the Lights for Final Installation After placement has been checked, it is time to prepare the grille lights for permanent installation. This includes hardwiring the lights, cauterizing the wires, to ensure the wires won't come loose, and covering the wires with electrical tape. For more details about this product, check out the video (0:31). Hot Installation Tip: Once the wires have been covered with electrical tape, make sure to heat the tape up, just like Mike does in the video. Heating up the tape will ensure the tape will not come loose. However, it is important to not overdo it, or you could end up repeating the entire process all over again. Step 4: Lights are Ready for Permanent Installation At this point, the surface mount lights are ready for permanent installation on the vehicle. To see Mike complete this process, check out the video (0:59). When preparing the light to be placed against the surface of the vehicle, don't place the cover over the light until the wire is nearly completely feed through the drill holes. Once the wire is feed through and the light housing is placed over the light, Mike is ready to install the light. To do this, he drills the light until it is tight against the body of the vehicle. It is important that the HL6 is screwed tightly to the body, so that it will not come loose during heavy duty use. Step 5: Connect Wires to Switchbox Our Charger's switchbox is located conveniently in the trunk. To see Mike connect the wires of the grille lights to the control box, tune in at (1:16). While watching the video, viewers can see that Mike takes his time carefully placing the wires around the swtichbox. In fact, he periodically stops to tie the wires together, so that the equipment is easier to store and deal with if needed. Step 6: HL6 Grille and Surface Mount LED Emergency Vehicle Lights are Ready to Go Voila! That's it, the grille and surface mount lights are ready to go. Installation Tips from our Resident Expert: If you have never completed this type of installation before, you are probably thinking "that looks easy enough." While it is true that these warning lights are easy to install, it does take a bit of experience and elbow grease to make it as easy as Mike makes it look in the videos. However, there are a few tips that viewers should keep in mind to make sure their installation goes smoothly. 1. Inspect all equipment as soon as it arrives and familiarize yourself with the components. 2. Locate the manufacturer instructions and read through them before beginning the installation. 3. Check all holes before drilling, and then double check. 4. Remember that your installation could vary from ours. If you have any questions about this video, the HL6 Grille and Surface Mount LED Emergency Vehicle Lights, or any of our other products, please feel free to comment here or contact us directly. Follow Us On Your Favorite Social Network! Facebook: https://www.facebook.com/911SignalUSA Twitter: https://twitter.com/911_Signal_USA Google+: https://plus.google.com/117281127414749163053 Instagram: http://instagram.com/911signalusa#





Which car is faster? Which Car is Faster?




Similar 1/4 mile timeslips to browse:

1995 Triumph Daytona 1200: 9.460 @ 143.000
JONATHAN PEDORENKO, Engine: 1200 CC, Tires: MICKEY THOMPSON


1995 Triumph Daytona 1200: 9.640 @ 142.000
JONATHAN PEDORENKO, Engine: 1200CC TRIUMPH, Tires: MICKEY THOMPSON


2005 Buell Firebolt xb12r: 9.944 @ 132.910
Brad Croneberger, Engine: 74 ci,


2005 Buell Firebolt XB12S: 10.222 @ 130.200
Stefan Graff, Engine: M-Tek, Supercharger: no Turbos: no Tires: MT MCR2


2001 Buell Firebolt XB: 10.400 @ 128.560
Piet Verhoef,


2006 Triumph Daytona 675: 10.717 @ 127.660
scott owens,


2008 Triumph Daytona 675: 10.750 @ 130.230
Oliver Demick,


1997 Triumph Daytona T595: 11.110 @ 126.330
Art G,


1997 Triumph Daytona T595: 11.140 @ 126.510
JR215, Tires: Pirelli super corsa


2008 Triumph Daytona Street Triple 675: 11.363 @ 118.590
My Friend Mike,


2008 Triumph Daytona Street Triple: 11.536 @ 118.850
My Friend Mike,


2008 Triumph Daytona Street Triple 675: 11.738 @ 118.000
My Friend Mike,


2007 Triumph Daytona Daytona 675: 11.759 @ 119.520
Grant F,


2004 Dodge Intrepid Nascar Nextel Cup Car: 11.900 @ 137.000
NA,


2008 Buell Firebolt XB12R: 11.948 @ 113.207
Mike Sumaya III,


2007 Buell Firebolt xb12r: 12.096 @ 112.950
Mike Place,


2000 Dodge Intrepid ES: 14.600 @ 95.000
Bekir, Engine: 3.2L, Supercharger: mone Turbos: none


2000 Dodge Intrepid ES: 14.600 @ 95.000
Leland, Engine: 3.5L v6,


2000 Dodge Intrepid R/T: 15.340 @ 92.620
Mr. J, Engine: stock 3.5L 242-horse V6, Tires: 225/55VR-17


2007 Suzuki Grand Vitara : 15.400 @ 89.890
Josh, Engine: j20a, Turbos: t3/t4 Tires: 235 65 16


 


©2014 DragTimes - Disclaimer - Contact Us