2009 Yamaha YZF-R1 Front Turn Signals Replacement

09 R1 Front Turn Signals Replacement with LED Flush Mounts from Grave Motor Sports

More Videos...


How to install LED turn signals
Welcome! Future motovloger! Its cold right now lol. Please subscribe! OEM CONNECTORS (most bikes!) http://www.customled.com/products/oem_connector/oem_connector.htm LEDS http://www.amazon.com/SIGNAL-Motorcycle-CRF230M-Aprilia-Kawasaki/dp/B009RCB KZG/ref=sr_1_5?s=automotive&ie=UTF8&qid=1394012504&sr=1-5&keywords=motorcyc le+led+turn+signals RELAY http://www.amazon.com/Tridon-EL12-Flasher/dp/B00064LOJ6/ref=sr_1_1?s=autom otive&ie=UTF8&qid=1394012567&sr=1-1&keywords=el+12+relay





2014 Yamaha R1 Crossplane Install Flush Mount Turn Signals Hotbodies LED Blinker Installation
This is how I installed the Hotbodies LED flush mount blinkers on a 2014 Yamaha R1 Crossplane. The white discs go directly on the turn signal which will space them out to sit flush with the front portion of the fairing. So, on your bike, 3 spacers go on the signal and 1 on the inner fairing to hold it down. 2009 to 2014 install flush turn signals on a 2014 Crossplane Yamaha R1. Hotbodies flush mount turn signal installation.





Audi R8 style lights on a Yamaha R1
Audi R8 style lights on a Yamaha R1. LED strip was installed and wired to operate as a turn signal as well as the running lights. I got the led strips from eBay; they are just 24 LED flexible strips. (Do a search there are hundreds) Next you will need 2 5 pin Bosch style relays. (Dont get the 4 pins they don't have an output for normally closed (87a) which is what you need for them to be running lights.) Next dismantle your bike down to just the headlights. Preheat the oven to 250 degrees Fahrenheit. Place the head light on a cooking sheet and then in the oven for 7 minutes. Remove headlight and pry the housing apart, its pretty easy with the help of a flathead screwdriver. Next glue in your LED strips; I used high temp silicone RTV on mine you can experiment if you like. Once installed lightly press the housing back together and put it back in the oven for 7 minutes when its done you can press it firmly together and the clips will re-snap down. Now just reassemble your bike and wire them up! you can wire it like I did as alternating with the flasher or if you dont want it to flash you can ditch the relays and wire it to any keyed 12 volt source on your bike. I happen to have used the stock 12v running light power for the stock signals (a blue wire as I recall.) Do this at your own risk I accept no responsibility if you confuse Fahrenheit for Celsius and melt your damn headlights :) Have fun kids!





YAMAHA YZF-R1 2009 (Crossplane) - Walk around
Walk around of my R1 super clean :) Bike: Yamaha YZF-R1 2009 Camera: Canon EOS 600D




Follow