My 94 rx7 with:
Racing Beat dual tip catback
High Flow Cat
Apexi AVC-R Boost controller
Tokico Illumina Shocks
Tein H tech springs
18" Kosei K3 rims
Im in Afghanistan right now, so i plan on heavily modifying it with new goodies when I get back. Ill put a new video up when I return!
1993 Mazda RX-7 (FD3S) HKS Hi-Power Exhaust
While shopping for an aftermarket cat-back Exhaust system for my FD, I had a hard time
deciding. My main struggle was finding good video or audio clips of
different set-ups on my vehicle to help me decide before purchasing. My
intention is to help others that may be in a similar situation as I was a
few months back.
**No Music on this one**
1993 RX7 Amuse R1 Titanium Exhaust **Rx7 Boutique**
More information about the car and my project can be found here:
http://www.rx7club.com/showthread.php?t=811195 . A R-magic titanium midpipe
should be added in the next few months. Imported by www.rx7boutique.com
Rx7 fd3 first time starting, bad water seal lots of smoke
First start after attempting many times a few days ago with no luck just
managed to flood it. This time i adjusted the idle screw out 1 turn as was
having to use the throttle before to keep it running what after a few
seconds would flood it, plugged the stock ecu back in, span the engine over
at full throttle with the coils unplugged, ecu/injector fuse out and plugs
out to clear the rotors of any fuel, heated my plugs up in the oven at 150
deg c for 10 minutes lol and started no problem.
The smoke from around the turbos is
because i heat wrapped the downpipe and it hasnt got hot before.
Has sat for over 4months without running in what time i slowley carried out
these mods, hks downpipe, hks rs intakes, blitz nur spec cat back, removing
air pump, removing ACV and solenoids, under drive pulleys, replacing all
the vacuum pipes under the UIM with silicone ones, fitting Efini Y Pipes,
hks hard pipes with samco hoses and of corse the Apexi power fc pro with
Lots of smoke in this video where it has a bad water seal. I knew about
this before starting it this time but wanted to check all the vac pipes etc
were good and it would start before looking in to the water prob any
Car is running good compression at the moment but dont know for how much
longer! Min 107 psi and max 115psi
Hopefully what i done above may help some of you others unflood your car!
The ecu fuse is next to the battery positive terminal and is the centre one
of the 5.
'88 RX-7 SE - Racing Beat exhaust
I installed a used Racing Beat Exhaust
today. I took video of the car with the catback removed (just the
presilencer), and with the new Racing Beat Exhaust installed. Sorry for the video quality
and background noise, my garage is on a busy street and I'm still working
out the details of using this camera with high contrast scenes.
MAZDA RX-7 FD3S WITH APEXi N1 EVO EXHAUST
This is a request from a you-tuber as there apparently is no other video of
an Efini FD3S RX-7 with the APEXi N1 Evolution 3.5'' de-cat Exhaust system.
Enjoy and leave your comments, if you have questions i will answer as soon
as possible. Any unexplained negative comments will be removed immediately.
If you are wandering as to why there is a lot of smoke its because the
engine is Cold and i use the IDEMITSU rotary premix which i might have put
if you want to know more spexs about my RX-7
view this video