Fun with a cop car - crown victoria p71
2002 Ford crown victoria p71 retired police car. This car just retired
from the force a few months ago and comes from the Oregon desert somewhere
lol. it was a highway patrol and is totally badass.
Crown victoria magnaflow exhaust with cobra front bumper
this is my 2003 ford crown victoria P71, 3.73 gears, port and polished
plenum, K&N FIPK intake system, custom tune by kurgan motor sports,
gatorback belt, cat back custom made 2.5" Exhaust with magnaflow mufflers and an x-pipe
with 3.5" tips, full audio system, custom dash with navigation, custom
gauges, McCulloch HID conversion, clear corners, dynamated interior, custom
made cobra bumper (i made it myself, no you cant buy it anywhere),
niteshade rear lights treatment, 35/25 front/rear tints, FULL ALARM SYSTEM
Crown Vic magnaflow exhaust
My 2003 P71 Crown Vic revving the Exhaust and playing around. Engine mods:
Original 4.6 pi v8, Professional Products aluminum Typhoon intake manifold,
Steeda 1/2" intake spacer, C&L RPM upper intake plenum, BBK 70mm throttle
body, Helex Power Tower throttle body spacer[for 01-04 Mustang gt] ported to remove
restrictive inner swirl to match TB opening & the plenum, K&N cold air
intake, Accel ignition coil packs, Summit Racing bracket racer underdrive
pulleys, Superchips performance programmer 1725 w/raised & firm shift
points, and 2.5" custom cat-back dual Exhaust w/h-pipe into Magnflow mufflers[pretty
mellow, no drone]. 3.5" JBA polished Exhaust tips. Fitch Fuel catalist. Home-made PCV
'03 Crown Vic P71 0-60, Top Speed, and Brake Demonstration
PLEASE READ BEFORE COMMENTING: This is my 2003 Ford Police Interceptor. I
decided randomly to stop and make this video on my commute home. The road
is hilly and not perfectly smooth so it's not a great choice, but it's what
I got. The video is from a stop full throttle to a top speed (If you
listen closely at 130-132 MPH the engine cuts back due to the limiter). My
rear axle bearings are bad and getting replaced today so that hurts the
speed too. The brake check towards the end was a full ABS stop from 120
ish (5.5 seconds) to show there is no noticeable brake fade from the
brakes. The front brakes are nearly worn out Raybestos Police Pursuit
Brakes (I Highly recommend them) the rear brakes are stock. The car is
100% stock and the temp outside today was around 75 degrees and humid.
My 2003 ford Police Interceptor In the SNOW!!!
This is me in the day time in my car, I just got the new tires on, and they
work great, with gas prices going down , I can actually afford to run this
This is where I got my car from in 2005 for $1,250 GREAT prices! Government
Car Auctions, Sign up and they give you lists of where all the Police
auctions and public auctions are. GOOD STUFF
Panzer's 4.6L P71 With Open Exhaust
Panzer's 2001 Crown Victoria P71 Police Interceptor 4.6L With Open Exhaust. Sorry speaker isnt very good on my
Hood came from here...
Crown Vic vs. Marauder
Me racing my 1999 Crown vic versus a Marauder at the huntsville drag strip.
I tried. Lol.....
My 2004 Crown Victoria Police Interceptor transformation into a Marauder clone.
My 2004 Crown Victoria Police Interceptor transformation into a Marauder
clone. Bought from Texas Department of Public Safety in January 2008. The
front clip was not changed out to the Marauder as these parts are very
expensive. The header is about $250, front bumper is $400, headlights $100
and grille about $125. Then the rear bumper is $500 from the dealer to
complete the whole look. Even junk yards wanted near retail for body parts.
So I just added the Marauder corners and smoked headlights. Cheaper and
still looks good and the average person has no clue the differences.