RV Tire Inflator - VIAIR 400P-RV Automatic Product Video
The VIAIR 400P-RV Automatic Portable Compressor is the perfect tool for
inflating RV tires.
Featuring a vibration-resistant diamond-plate sand tray, heat-shielded
quick connect coupling, and an 8ft power cord, this unit can inflate tires
up to 150 PSI, well above the required pressure for RV tires.
It also includes a Tire Inflation Gun, Dual battery clamps, a 3 piece
inflation tip kit, a heavy duty deluxe carry bag and two coil hoses for up
to 60ft of reach.
Remove the orange rubber plug and screw in the air filter to prevent dust
and moisture from entering the system.
Pop open the hood and connect the dual battery clamps to the battery.
Always remember, red to red and black to black. Once connected, make sure
to start the engine to provide the required voltage.
Pull back the sleeve of the quick connect coupler on the primary hose
firmly to quick connect stud on the compressor. Connect the other end of
the primary hose to the male end of the Tire Inflation Gun. Next connect
the 90-degree twist on chuck to the female end of the tire inflation gun.
Remove the valve stem cap, attach the twist-on chuck to the tire valve stem
and secure it by tightening.
Power the compressor by pushing the ON switch on the front of the
compressor. Squeeze the trigger of the inflation gun to inflate the tire.
Make sure you don't over-inflate the tire past its recommended pressure, as
doing so can damage your tire and may cause serious bodily injury.
To get an accurate pressure reading, simply release the trigger of the
inflation gun. When the pressure gauge indicates the desired pressure,
remove the twist-on chuck from the tire valve stem.
To reach the back tires, you may need to use the extension hose included.
To do so, pull back the sleeve on the quick connect coupler of the primary
hose and connect it to the male end of the extension hose. Then reconnect
the extension hose to the tire inflation gun.
If your RV has Dual Rear tires, you can use the 45-degree push-pull chuck
VIAIR's 400P-RV Automatic Portable Compressor makes tire inflation easy and
affordable to help ensure your RV is in optimal running condition.
31" x 10.5" Fill Rate
0 to 30 PSI 2 min. 28 sec.
15 to 30 PSI 1 min. 25 sec.
33" x 12.5" Fill Rate
0 to 30 PSI 4 min. 00 sec.
15 to 30 PSI 2 min. 00 sec.
35" x 12.5" Fill Rate
0 to 30 PSI 4 min. 50 sec.
15 to 30 PSI 2 min. 20 sec.
On Board Air The Right Way
On board air using a Sanden compressor with additional stuff to utilize oil
in the compressor crankcase to achieve constant duty and high speed for
filling tires and running impacts. For more information log on to
XJTalk.com and browse On Board Air in the Technical How To section.
Tire Inflator - VIAIR 85P Portable Air Compressor
The VIAIR 85P is a smaller portable compressor that plugs into your
accessory power port to fill passenger car tires up to 225/60R18. (Requires
a 15-amp power circuit).
195/70R14 Fill Rate
0 to 30 PSI 2 min. 00 sec. (+/- 10 sec.)
15 to 30 PSI 1 min. 00 sec. (+/- 5 sec.)
225/60R18 Fill Rate
0 to 30 PSI 2 min. 50 sec. (+/- 10 sec.)
15 to 30 PSI 1 min. 30 sec. (+/- 5 sec.)
31" x 10.5" Fill Rate
0 to 30 PSI 4 min. 30 sec. (+/- 15 sec.)
15 to 30 PSI 2 min. 15 sec. (+/- 5 sec.)
For more information on the VIAIR 85P Portable Air Compressor, visit
Viair onboard air system - install and overview
This is a full install video of a Viair Ultra Duty onboard air system. This
system was installed on a 2011 Super Duty, and powers a train horn, and QD
fitting for air tools. This system is 200PSI
Don't forget to ALWAYS have your vehicle running while using the
Get yours at: http://www.viaircorp.com/oba-ultra.html
VIAIR: Serious About Compressors
Here at VIAIR we take our jobs very seriously. We're always looking for
new and exciting ways to utilize our air compressors, but not every idea is
VIAIR 70P Portable Compressor (P/N 00073)
The 70P Portable Compressor from VIAIR is the perfect tool for inflating
compact and mid-size car tires.
Featuring a 150 PSI Pressure Gauge, 3pc. Inflation Tips Kit, Accessory
Power Plug, and a Deluxe Carry Bag, this air compressor is capable of
inflating 225/65/R18 tires or lower.
1. Plug the accessory power plug into your vehicle's power outlet and start
the engine to provide charging voltage.
2. Remove the valve stem cap, attach the end of the air hose to the tire
valve stem and secure it by tightening the twist-on chuck.
3. Power on the compressor by pushing the ON switch on the front of the
compressor. The tire will now inflate. Make sure you don't over-inflate
the tire past its recommended pressure, as doing so can damage your tire
and may cause serious bodily injury.
4. When the pressure gauge indicates the desired pressure, switch the unit
OFF and remove the air hose from the tire valve stem.
5. Finally, place the cap back on the tire valve stem and unplug the power
cord from the outlet.
VIAIR's 70P Portable Compressor makes tire inflation easy and affordable to
help ensure your vehicle is in optimal running condition.
VIAIR 70P Portable Compressor (P/N 00073)
1.27 CFM @ 0 PSI
15% Duty Cycle @ 100 PSI
195/70R14 Fill Rate:
0 To 30 PSI 2 Min. 55 Sec. (+/- 10 sec.)
15 To 30 PSI 1 Min. 45 Sec. (+/- 05 sec.)
225/60R18 Fill Rate:
0 To 30 PSI 4 Min. 22 Sec. (+/- 10 sec.)
15 To 30 PSI 2 Min. 10 Sec. (+/- 05 sec.)
VIAIR Jeep JK 2007-2011 2on2 Bolt-On Platform Installation
VIAIR's 2on2 Bolt-On Platform is the newest solution to air management for
Jeep JK owners. Using either two 400C (High Speed) or 380C (High Pressure)
compressors at its core- and mounted on a 2.0 gallon 5-port air tank, these
vehicle-specific units provide more than enough CFM to accomplish virtually
any pneumatic task. The 2on2s all come complete with an easy-to-install
wiring harness and manifold to make wiring and plumbing the system
straightforward. Vehicle-specific bolt-on platforms for 2007-2011 Jeep JKs
are equipped with a crossmember mounting bracket.
Superflow MV90 verses MV50 Air Compressor comparison
This video is a side by side comparison used to illustrate the performance
differences between the SuperFlow MV90 and MV50 12-volt Portable Air
Compressors. Because of additional hoses and fittings required for the
test, actual performance of the units when used individually is better than
what you see here. The test truck is an 2008 F250 Super Duty Diesel with
275-70-R15 Tires. Both units come with a nylon carry bag and coil air
hoses. Newer models are equipped with type M air fittings making it easy
to use your own hoses. Caution -- These compressors are designed to
provide continues flow of air. Never use a hose set-up that dead ends the
flow of air.