When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $48.79
- Condition: New
- Color:Black
- Warranty:10 Year
- Please be sure you review the compatibility information.
- If you have a question about the part please free contact us before buying, we will give you a best reply in time.
- We are galde to offer quality service and vehicle parts to you, any after salequestions please message us before open case or feedback, we will give you thebest solution.
Specifications
- Condition: New
- Color:Black
- Warranty:10 Year
Note
- Please be sure you review the compatibility information.
- If you have a question about the part please free contact us before buying, we will give you a best reply in time.
- We are galde to offer quality service and vehicle parts to you, any after salequestions please message us before open case or feedback, we will give you thebest solution.
Replacement Guideline
Ball joints
- Purchase the correct replacement ball joint assembly for your vehicle.
- Remove the wheel and access the ball joint.
- Soak all the bolts with WD-40 or PB Blaster.
- Pull the cotter pin and loosen the large castellated nut.
- Pop loose the ball joint.
- Remove the allen bolts and slide the control arm free.
- Guide the new joint through the knuckle hole.
- Bolt the joint into place using the hardware included.
- Torque the bolts to the proper specifications.
- Screw in the new grease fitting and pump grease into the assembly.
Control Arms
- lift the vehicle using a car lift, ideally a wheel-free four-post car lift
- loosen and remove the corresponding stabiliser fixing screws.
- Loosen the ball joint at the steering knuckle with a suitable special tool (e.g. a puller).
- Remove the old control arm
- Clean the mounting flange of the ball joint pin on the steering knuckle with sandpaper and then with brake cleaner
- Fit the new control arm with the supplied accessories and attach new fixing screws and nuts.
- Reattach the stabilizer and, if applicable, the leveling sensor for headlight leveling to the control arm.
- lower the vehicle until the suspension is compressed
- Tighten the fixing screws with the torque stipulated by the vehicle manufacturer.
- Lower the vehicle all the way.
- Measure the chassis and adjust if necessary.
- Check and, if necessary, adjust the headlight settings on vehicles with automatic headlight leveling where the leveling sensor is attached to the control arm.
- To conclude, test-drive the vehicle.
Sway bars
- To hold the stud on the end of the sway bar link while adding the new lock nut.
- Using the wrench, install the new lock nut, making sure to wrench it the whole way.
- With the sway bar link in position, put the nut on using your hand.
- Wrench the nut tight to the vehicle manufacturer recommended torque values
- Changing wrenches as needed to fit the new sway bar link nut.
Bad Controlarm symptons
- popping noise
- steering is unstable
- uneven tire wear
Signs ofa ball joint breaks
- Sound-Afaint, intermittent clunking noise that seems to be coming from a corner of your vehicle
- Steering-The steering sloppy or stiff
- Tires-Uneven tire wear
Signs ofsway bars breaks
- Rattling and thumping noises on rough roads.
- Imprecise vehicle handling.
- Stronger inclination of the vehicle during cornering.
Infiuence of a badjoint break
- Causingmysterious clunking noise or drifting steering
- Affectingyour steering and suspensionseriously
Importance ofControl Arms
- Itis a link that connects the frame of the car to the wheel hub assembly or steering knuckle.
- Itallows a driver to steer a car while also guiding the wheels up and down with the road surface.
- Theyhave a vital role in a vehicle's overall stability and drivability.
Infiuence of a badsway bars
- Without the sway bar, the car will not handle and corner as well, or as comfortably for the driver and passengers
Item SpecificsPlacement on Vehicle Front,Lower,OuterBrand auspartshouseManufacturer Part Number 10022875Number of Kit Pieces 6 pcsManufacturer Warranty 10 YearFitment Type Direct ReplacementMounting Hardware Included NoInterchange Part Number K5342, K5331, ES3459Suspension Grade StandardCustom Bundle YesModified Item NoColor BlackSurface Finish PolishedPackaging New in BoxType Control Arm & Ball Joint AssemblyAdjustable YesGreasable YesSuperseded Part Number 10285683, 10285684, 10292672, 10403402
Payment We use eBay's Safe and Secure Checkout. Just click the Pay Now button at the top of any of the auctions you have won.To pay for multiple auctions, successfully win all auctions you wish to purchase and then click the Pay Now button on any of the listings you won. You will only have to checkout and pay once for your entire order.Please review our detailed policies on shipping and fixing any issues before purchasing the item. If you have any questions, please email us through "Ask a question".Payment Options: Paypal, G Pay, Visa, Mastercard, American Express, and Discover.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages within 12 hours.Payment must be received within 10 days as auction ended or order might be delayed.Shipping
1. More than 90% orders processed within 24 hours of payment verification.
2. We only ship to the address in order provided to us. Your PAYPAL address will not berecognized as shipping address.
3. The images shown is the the actual item you will get and the size are for your reference.
4. If you have not received your shipment within 15 days from payment, please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
Returns1. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
2. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
3. Return shipping is to be paid by the Buyer if the problem turned to be buyer's end, or return will be seller's responsibility.
FeedbackWe maintain high standards of excellence and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Contact UsAny question or problem, please feel free to contact us via ebay message.
DESCRIPTIONPAYMENTSHIPPINGRETURN POLICYCONTACT US Just Get It NOWShop CategoryStore Home Wheel Spacers Leveling Lift Kits 3RD Brake Lights LED Instrument Lights Tire Pressure Sensors Fasteners Remote Keys Sun Visors Roof Racks Ballast Modules Rubber Seal Strips Throttle Body Thermostat Housing Fuel Injectors Coilovers Ignition Coils LED Whip Lights Wheel Hub Bearing Suspension Kits Window Regulators Sensors◈Other Sensors◈Oxygen Sensors◈ABS Sensors◈Knock Sensors Mud Flaps Solenoids Lift Supports◈lift support sale◈lift support Resistors HVAC Blower Motors Radiators Cooling Fans Coolant Overflow Tanks Engine Gaskets Blend Door Actuators Tonneau Covers Air Suspensions AC Condensers Heater Cores Window Switches Door Handles Shock Struts Windshield Wiper Motors A/C Compressors Timing Chain Kits Timing Belt Kits Turbochargers Radiator Supports Mirrors A/C Evaporators Engine Motor Mounts Starters Alternators Brake Calipers Power Steering Pumps Tensioners Brake Rotors Brake Pads Fuel Pumps Water Pumps Driveshafts Idle Air Control Valves Power Steering Rack & Pinion VVT Variable Valves Lug Nuts Steering Shafts CV Axles Oil Pans Hydraulic Lifters Towing Parts Steering U-Joint Parts Door Lock Actuator Spoilers & Wings Lawn Mower Parts◈Blades◈Clutch◈Blade Holder OtherHot Item For 00-06 GMC Yukon XL 2500 Rear Window Glass Lift Supports Struts Liftgates 2pc USD 16.79 2 Front Hood Lift Support Struts Shocks for 1999-2004 Jeep Grand Cherokee 4.0L USD 14.99 2pcs Rear Liftgate Tailgate Lift Supports Struts For 2001-2007 Chrysler Town L+R USD 29.59 Front Hood Lift Support Shocks For 91-01 Ford Explorer 97-01 Mercury Mountaineer USD 13.59 For 2004-2015 Nissan Titan Front Hood Gas Charged Lift Supports Shocks Struts X2 USD 17.59 New List Item 80478 Door Handle For 2007-2013 CHEVROLET SILVERADO Exterior Rear Right Side USD 13.69 4X Strut Shocks w/ Coil Spring Assembly For Honda Civic DX EX 2001-2005 171340LO USD 240.99 1x Interior Front Left Door Handle Gray For Honda Accord 1998-2002 3.0L V6 L4 USD 11.99 For Chevy GMC C/K 1500 V8 95-00 2x Outside 4x Inside Door Handles Left Right USD 49.99 4x Door Handles Gray Black For Chevy GMC Pickup Truck Exterior Interior Front USD 31.99 Fits 98-02 Oldsmobile Intrigue Chevy Impala 6x Ball Joint Outer Tie Rod Sway BarSpecifications
- Condition: New
- Color:Black
- Warranty:10 Year
Note
- Please be sure you review the compatibility information.
- If you have a question about the part please free contact us before buying, we will give you a best reply in time.
- We are galde to offer quality service and vehicle parts to you, any after salequestions please message us before open case or feedback, we will give you thebest solution.
Replacement Guideline
Ball joints
- Purchase the correct replacement ball joint assembly for your vehicle.
- Remove the wheel and access the ball joint.
- Soak all the bolts with WD-40 or PB Blaster.
- Pull the cotter pin and loosen the large castellated nut.
- Pop loose the ball joint.
- Remove the allen bolts and slide the control arm free.
- Guide the new joint through the knuckle hole.
- Bolt the joint into place using the hardware included.
- Torque the bolts to the proper specifications.
- Screw in the new grease fitting and pump grease into the assembly.
Control Arms
- lift the vehicle using a car lift, ideally a wheel-free four-post car lift
- loosen and remove the corresponding stabiliser fixing screws.
- Loosen the ball joint at the steering knuckle with a suitable special tool (e.g. a puller).
- Remove the old control arm
- Clean the mounting flange of the ball joint pin on the steering knuckle with sandpaper and then with brake cleaner
- Fit the new control arm with the supplied accessories and attach new fixing screws and nuts.
- Reattach the stabilizer and, if applicable, the leveling sensor for headlight leveling to the control arm.
- lower the vehicle until the suspension is compressed
- Tighten the fixing screws with the torque stipulated by the vehicle manufacturer.
- Lower the vehicle all the way.
- Measure the chassis and adjust if necessary.
- Check and, if necessary, adjust the headlight settings on vehicles with automatic headlight leveling where the leveling sensor is attached to the control arm.
- To conclude, test-drive the vehicle.
Sway bars
- To hold the stud on the end of the sway bar link while adding the new lock nut.
- Using the wrench, install the new lock nut, making sure to wrench it the whole way.
- With the sway bar link in position, put the nut on using your hand.
- Wrench the nut tight to the vehicle manufacturer recommended torque values
- Changing wrenches as needed to fit the new sway bar link nut.
Bad Controlarm symptons
- popping noise
- steering is unstable
- uneven tire wear
Signs ofa ball joint breaks
- Sound-Afaint, intermittent clunking noise that seems to be coming from a corner of your vehicle
- Steering-The steering sloppy or stiff
- Tires-Uneven tire wear
Signs ofsway bars breaks
- Rattling and thumping noises on rough roads.
- Imprecise vehicle handling.
- Stronger inclination of the vehicle during cornering.
Infiuence of a badjoint break
- Causingmysterious clunking noise or drifting steering
- Affectingyour steering and suspensionseriously
Importance ofControl Arms
- Itis a link that connects the frame of the car to the wheel hub assembly or steering knuckle.
- Itallows a driver to steer a car while also guiding the wheels up and down with the road surface.
- Theyhave a vital role in a vehicle's overall stability and drivability.
Infiuence of a badsway bars
- Without the sway bar, the car will not handle and corner as well, or as comfortably for the driver and passengers
PaymentShippingReturnsFeedbackContact Us We use eBay's Safe and Secure Checkout. Just click the Pay Now button at the top of any of the auctions you have won.To pay for multiple auctions, successfully win all auctions you wish to purchase and then click the Pay Now button on any of the listings you won. You will only have to checkout and pay once for your entire order.Please review our detailed policies on shipping and fixing any issues before purchasing the item. If you have any questions, please email us through "Ask a question".Payment Options: Paypal, G Pay, Visa, Mastercard, American Express, and Discover.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages within 12 hours.Payment must be received within 10 days as auction ended or order might be delayed.
1. More than 90% orders processed within 24 hours of payment verification.
2. We only ship to the address in order provided to us. Your PAYPAL address will not berecognized as shipping address.
3. The images shown is the the actual item you will get and the size are for your reference.
4. If you have not received your shipment within 15 days from payment, please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
1. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
2. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
3. Return shipping is to be paid by the Buyer if the problem turned to be buyer's end, or return will be seller's responsibility.
We maintain high standards of excellence and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Any question or problem, please feel free to contact us via ebay message.
All rights reserved.