When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $17.65
Qty(2) Acura TL 2006 To 2008 Front Hood Lift Supports Shocks Struts Springs Gas
If you don\'t want to wait, click here:Item Description
Brand new and warranty offered!!
Ensures easy installation and precise operation
Individually tested for performance and reliability
Direct fit
Patented Multi-Lobe Seal makes gas springs more tolerant to vibration andtemperature extremes
Premium gas-charged cylinders
Twin Tube internal construction
Specifications
This Listing is for2 Supports which fit the Following Applications:
2006-2008 Acura TL Base Sedan 4-Door Hood
2006-2008 Acura TL Type-S Sedan 4-Door Hood
Important Notes about Lift Supports
1. Each support is tested to perform as well as the original units and in manycases to exceed the manufactures specification, please ensure you replace allthe
supports in the compartment at the same time to ensure proper performance.
2. Lift supports loose pressure over time, even sitting on shelves in most autoparts stores and many of the inventory liquidators on . Our business is liftsupports, and we make sure to sell newly produced units, keeping our inventoryfresh and rotated.
How to Properly Install a standard Lift support?
1. Use Safety standswhenever a procedure requires you under the vehicle or supports. Or have someonehold the lid open for you so that they can raise or lower it as needed.
2. Before removing the old lift support, inspect the end connections and comparethem to the units on your vehicle to make sure that they are the same As well asthe extended length.
3. Remove the old support from the vehicle by placing a small flat headed screwdriver under the U shaped band on the ends of the support. Slowly turn the screwdriver and it will lift up on the band approx.1/8\", then pull the support awayfrom the vehicle and it will release.
4. To install the new supports do the same procedure in reverse. DO NOT jam thenew support end over the ball socket without lifting the U band slightly ordamage may occur.
5. Lift Supports need to be installed fully extended. In most cases you justcan\'t compress them unless they are on the vehicle. If you have any issuesduring the installation PLEASE contact us. Never force a support.
6. If the ends are not lining up the support may need to be turned. To do thisattach the shaft end of the support to the vehicle and then turn the entire bodyof the support clockwise unit the ends line up.
Related Hot Deals
Still Looking Lift Supports ? (Following Photos Reflect The Actual Product, Click Them, YouCan See Them Precisely)For Chevrolet GMC For DodgeFor Dodge For JeepGrand