When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $16.99
***Attention NYS residents***
Due to current and pending changes to NYS tax regulations, we will no longer ship to purchasers in NYS.
We are truly sorry for this buthopefully this will change in the near future.
REPLACE THE LEAKING PLASTIC \"Y\"
NOT THE WHOLE EXPENSIVE HOSE ASSEMBLY
with our
ALUMINUM Y FITTING KIT.
BET YOU\'RE SHOCKED AT THE COST OF THE REPLACMENT HOSE....
IT\'S OVER $50 BUCKS FOR AFTERMARKET AND CLOSE TO $200 FOR THE FACTORY PARTS!
If the rubber hoses are good, why not just replace just the leaking PLASTIC Y with metal?
You retainthe factory branch hoses and save big bucks over the cost of the fullhose assembly.
Our\"TRUE Y\" KIT has all thehose andclamps needed,
in 10-15 minuteswhat was originally a $400 dealer repair is now a fraction of the cost!
Cut the lower hose of the assembly at the downward bend
(just after the crimped plastic clamps)
slide the new metal \"TRUE Y\" in its place
install the newsection of hose
Tighten the hose clamps andyou\'re DONE, back on the road in10 minutes.
SEE THE YOUTUBE REPAIR VIDEO OF OUR SIMILAR \"WELDED Y\" BY CLICKING HERE
This cast aluminum Y will work with the front return hose assembly or the rear supply hose assembly.
For this repair to work correctly, the remaining factory heater hose MUST be cut back and inch or so past the old factory plastic Y. Trying to remove the old factory molded plastic clamps and the leaking plastic Y without cutting back the hose leaves a section of hose which was stretched over barbs on the old factory plastic fitting. The hose i.d. is stretched over 5/8\" at that section, as a result, it will not seal properly on the new 5/8\" fitting. Overtightening the new hose clamps to compensate will result in the clamps breaking, too loose and there will be leaks. They just need to be snugged down on the new Y fitting to the point where the hose cannot be rotated on the fitting, the bead on the new fitting will take care of 90% of the sealing.
Made of THICK WALL ALUMINUM for the auto industry, this is a superior alternative toPLASTIC.
ALUMINUM Y FITTING REPLACMENT FOR (Four Seasons/Murray Hose Fitting 84757, GATES 28634, DORMAN 47117) USED WITH (Gates 23933 , DORMAN 626-307 , MOPAR 4677603) & 5/8\" HEATER HOSE.
You maynote that First Class USPS is not an option.
Itmay be acheaper shipping alternative but also has a higher rate ofdelays and lost items.
We now only ship USPS PRIORITY MAIL,it gets to you faster (usually in 1-3 days).
During peak shipping seasonsthere WILL be delays with the USPS, expect an additional day or two travel time.
We warranty this product to be free from any defects in materials or workmanship for a period of one (1) year from the date purchased. If during the warranty period this product is found to be defective, we will at our discretion repair or replace the item. This warranty does not cover labor or any other incidental expense incurred due to failure. Any damage caused by improper installation or adjustment, accidents, modification, salt corrosion, road damage, stress or misuse is not covered. We do not provide any warranty in relation to any liability in relation to any property or injury, including death to any person or persons, including customer, or any loss, cost, expense or lost opportunity suffered or incurred by any person directly or indirectly relating to, or arising out of, any use of this product. This warranty does not authorize any customer or entity to act on our behalf in regards to any warranty settlement.