When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $11950.00
LS7 Long block engine. The engine was removed from a 6k mile 2007 C6 Z06, it was originally purchased from Chuck Ryan at Vettewrecks.com. I was planning on using it for a swapped car but have changed my plans on the power plant. The engine internally has not been opened with the exception of putting the Propan oil pan on. The engine will require final install with new gaskets of the oil pan, intake manifold and front accessories. The heads were never removed and are ready to go low mileage factory. The intake manifold and front accessories were installed for shipping purposes. All aftermarket parts are brand new never used. They were simply installed for mock up and fitment purposes. The list of parts included with this are as follows:-LS7 with 6k miles out of a wrecked \'07 Z06 from Chuck Ryan at Vettewrecks.com
-Used GTO Starter
-Fuel Injectors - Blue printed and balanced from Mike Yeager at East Coast Performance (52lb@3bar 43.5psi, so with your fuel system set at 58psi, that will make them 60lb@4bar) - matched for base tune on PSI ECU
-FAST Fuel Rails
-FAST 102 Intake
-Swirl Ported Throttle Body powder coated black
-Front Drive: KRC Front Drive Y Body PRO SERIES PUMP WITH BOLT ON RES
-Front Drive: Katech Tensioner anodized red with black anodized pulley
-Alternator with black anodized pulley
-Custom Black Meziere Billet Mechanical Water Pump - anodized black
-ATI Fluid Dampener
-ARP Crank Bolt
-Custom ProPan Oil Pan (Doug Lee at Propan)
-AVIAID Oil Tank and Baffle (110-51007 LS 7/9 Dry Sump Tank Insert)
-Improved Racing Oil Cooler Adapter - anodized black
-PSI Harness/ECU- comes with factory base tune matched to setup - comes with installation manual - custom mil spec connector for firewall connection
-(8) factory coil packs, matching plug wires and factory valve cover bracket
-Custom 4-1 stainless headers, 3\" v-band flange - were built for a custom setup - may need to be modified to fit the car this engine is installed into (open to offers without headers if necessary - please confirm with me)
-Misc OEM sensors
-OEM Z06 plastic intake duct with air filter
-OEM fuel rail
-OEM oil baffle and oil dip stick If one were to purchase all of this individually, add in shipping, etc the total is quite a bit. Great chance to save thousands on this custom setup. If you have any specific questions on the setup, please don\'t hesitate to contact me. The unit will be fully enclosed on a pallet for shipping. Shipping is estimated for commercial shipping address in continental US. If shipping will be anything other than specified, there may be an increase. Thank you.