When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $89.99
Grey Dash Kit for Jeep Grand Cherokee2005-2007
Up until now installing an Aftermarket Double Din Radio into the 2005-2007 Jeep Grand Cherokeemeant having tobuy thefactorynavigation bezel ( $175 ), an aftermarket radio install dash kit ( $12 ), wiring harness and a antenna adapter ($6). Howeverour newkit allows you to replace your Factory Radio with an aftermarket Double Din radio at a reasonable price with a cleaner look. We have taken the extra steps out for buyingmultiple parts and lowered the priceplus you will get a better looking installed with our kit.
This installation kit contains: The Aftermarket Trim Bezel Double Din Dash Kit, Antenna Adapter and Wire Harness
For more buying options including wiring harness and colors please click here to be directed to a different auctionClickHere!
Installation Directions-
Tools needed for install -Philips screw driver,Dremel(rotary tool)and a Soldering Iron.You can buy a Soldering gun at Harbor freight for as low as $3.99 and a Dremel (rotary tool) knock off for $10.79 or just look oneBay.
Step 1: Gently pull on the factory bezel, it is only held on by a few plastic tabs up top and there are 2 clips on each side of the AC vents (totaling 4)and 1 clip at the bottom..
Step 2: You will see 4 Philips screws holding the factory radio in place, remove the screws and the radio will be lose and ready to come out.. Keep the screw for installation of new double din radio..
Step 3: Next unplug all the wire harness and antenna cable leading into the factory radio. You will now have the empty hole ready for new double din radio and your newly purchased dash kit
(DO NOTDISCARDTHE FACTORY BEZEL AS YOU WILL NEED THE AC VENTS TO PUT ON THE NEW BEZEL)
Step 4: The removal of the AC vents from the factory bezel. Please see video below..
Step 5: Install the factory AC vents to the newly purchased aftermarket bezel. Please see video below.. Do this installation on a soft, clean, or protected surface as to not scratch the face or your new bezel..
***Note while installing AC vents to new bezel, apply firm pressure while melting down the tabs so the AC vents will be flush***
Step 6: Screw the supplied brackets onto the side of your aftermarket double din radio ( using the supplied screw that came with the aftermarket radio)
Step 7:Wire the aftermarket radio harness to the harness supplied using butt connectors or solder wiring together.
Step 8:Plug in aftermarket radio harness to aftermarket radio & install harness to factory radio plug.
Step 9:Connect antenna adapter to factory antenna end & aftermarket radio.
Step 10:Using the same 4 screws you used to take out the factory radio, screw in your new double din radio.
Step 11:SnapNew dash bezel back into dash.
Make sure radio looks even from side to side and top to bottom, should be a nice even fit all the way around. You may need to readjust the brackets slightly to make radio completely centered.
ENJOY YOUR NEWLYMOUNTRADIO AND BEZEL