This item has been shown 0 times.
Previously used Esslinger intake.Fits thedual Weber DCOE carburator design. This intake will notfit a stock cast ironFord Pinto / Ranger 2.3L / 2300 CC SOHC head. Esslinger makes this intake to fit its SVO, and Arca aluminum head. Part number M9424A230.
This intake shows signs or wear. It is in below average condition. Some bolt holesfrom the intake to the head are ovaled out. I could not find any stripped threads on the intake to carbs. This intake has been altered. It had a hole drilled and tapped into each port. There is a brass air nipple installed in each port. This design is used to measure vacuum pressure to adjust the carbs. I left three nipples installed, and put a plug into one hole.
These intakes equipped with a dual Weber carb set up are great compliments to any 2300cc Pinto engine. Used succesfully for decades in Pro four, Late Model Light, Midgets, Sand Rails, Salt Flat cars, T-bucket roadsters and Dragsters.