When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Price: $69.99
Bundle & save!!!
Includes....(1) Crankshaft pulley removal tool (reference MD998754/MB990767-01)(1) set of camshaft gear locks to prevent movement of camshafts/alignment marks.(1) timing belt tensioner pulley tool (MD998767 old # MD998752)
Don\'t miss out on these essential tools to do a timing belt change on your 3000GT / Stealth! Save time and headaches, do the job right!
These tools are built for some abuse! Unlike the other tools being sold, the timing tensioner tool & crankshaft pulley tools are made from stainless steel & hardened stainless steel pins, the gear locks are solid 6061 aluminum! These tools are proudly made in the USA!
timing belt tensioner pulley tool....Use either a 3/8\" drive wrench, or use the supplied adapter to use a 1/4\" drive wrench.This tensioner tool will never rust and if you accidentally over torque the pulley, the pins will take a lot more torque before they bend/break compared to mild unhardened steel.A torque wrench should always be used, but the tension can be adjusted by feel & double checked by the grenade pin (see your service manual).This tool makes a timing belt change much easier. You simply plug the tool into the tensionerpulley, insert a 3/8\" drive wrench, or use the supplied adapter for a 1/4\" drive, and turn in order to apply the correct amount of tension to the timing belt.
crankshaft pulley removal tool....This removal tool will never rust and if you accidentally over torque the pulley bolt, the pins will take a lot more torque before they bend/break compared to mild unhardened steel.Simply plug in a 1/2\" drive wrench or breaker bar, which can then be held or lay against the axle or lower control arm, then use either a socket or 1/2\" wrench/breaker bar to turn the bolt.
gear locks....There is an amount of tension from the lobes/springs that forces the gears to rotate, making it very difficult to keep the timing marks lined up. Use these to keep your camshaft gears from rotating while you install the timing belt. Made from aluminum, these will not damage your gears. They also have a hole for hanging while not in use.
The last two images in the picture gallery show the tool dimensions. Please use them to double check against your pulley to make sure they will work.
Feel free to message me with any questions!