For 99-02 Chevy Silverado 00-06 Suburban Tahoe Headlights + Bumper Signal Lamps for Sale

Price: $71

This item has been shown 102697 times.

For 99-02 Chevy Silverado 00-06 Suburban Tahoe Headlights + Bumper Signal Lamps

Item Description:


APPLICATION:

For 99-02 Chevrolet Silverado 1500 2500 3500


For 01-02 Chevrolet Silverado 1500 HD 2500 HD


For 00-06 Chevrolet Suburban 1500 2500


For 00-06 Chevrolet Tahoe



FEATURE:

Chrome Housing Clear Lens


DOT & SAE for street legal


Great Replacement or upgrade for factory headlights


Adjustment screws for high/low beam


Low Beam Bulb Type: 9006 HB4 (bulb not included)


High Beam Bulb Type: 9005 Hb3 (bulb not included)


OEM Part Number:GM2503187,GM2502187


Interchage Part Number: 16526134,16526133

PACKAGE INCLUDES:

1 Pair Set of Left Driver Side + Right Passenger Side Headlights Headlamps



HOW TO INSTALL:


1.Undo the screws, clips, or retainer springs that hold the headlight in place.


2.Disconnect the wiring from the assembly.


3.Detach the headlight from the vehicle to replace it with a new one.


4.Fit in the new headlight assembly.


5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.


6.Reconnect the wiring that was unplugged from the assembly.


7.Put back the grille and other components that you removed. Seal them back into place.

HOW TO ADJUST:

Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than3.5 feet above the ground.


1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle.


2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair infront of the light you want to block. Covering the light assembly directly can damage the plastic lens.


3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights andcounterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the lightbeam shines directly on or just below the center of the tape line on the wall.


4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left adjustmentcorrect. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.


5. Test your results.

More Display:

On May-28-20 at 00:23:07 PDT, seller added the following information:



Parts Search:


Follow