2002 Dodge Ram 1500 Engine Swap 4.7L Part 1 - EricTheCarGuy
Link to full version of this video:
Link to part 2: http://www.youtube.com/watch?v=QES-WrAB1NI
Visit me at: http://www.ericthecarguy.com/
This truck has been a challenge for me over the past couple of weeks as you
will seen in the video. The lesson here is do your best to check the
engine out before you install it and even that may not be enough. Be
careful when doing a job like this especially if you are by yourself as you
can get seriously injured if your not careful so work carefully and
methodically and things should work out fine.
The music is from the site
under "Royalty Free Music", it's title is "Merry Go-Distressed", the
producer of the site allows the use of this music as long as credit is
given, hence the credit given here. Thank you!
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
Visit EricTheCarGuy Forum
Visit my Facebook Page:
Be safe, have fun and stay dirty.
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.
HOW TO make your exhaust LOUDEST
*STOP the comments on how bad the welds were. I know they were shit. Take
a look at the rust I was welding on. This was one of my first times
welding. I didn't know you had to get the welding surface to bare metal
back then. Also, I was working with a 110 harbor freight welder.*
This is a video on how to make your Exhaust straight piped but still look like you
have a muffler.
WARNING: Doing this mod may make your vehicle not pass inspection or
emissions. Keep that in mind if you want to make your Exhaust straight piped.
Check out my YouTube channel for other how-to videos and other Exhaust videos!
My vehicle is a 1991 Toyota 4Runner with a 3.0 V6 5 speed. Lifted 3" with
Feel free to comment with any questions.
Dodge Ram 4.7L with magnaflow
This Magnaflow makes a deep sound that is not audible on Laptop or low end
computer speakers. Sorry but to really hear it you need at least a good 2.1
I replaced the stock Exhaust with a
Magnaflow Dual in Dual out muffler. I cut out the stock Y pipe, so this is
a true dual system. The muffler has a built in X-pipe. This video showcases
the sound during Start-up, idle, and regular driving. It is a little longer
than most to give a good impression of the sound on the streets.
► Dodge Ram 2500 [Off-Road 4x4]
Dodge Ram 2500 [Off-Road 4x4]
- AUTHOR: Roman Gapon (http://www.youtube.com/watch?v=7FTcEnWwh9Q)
- If you want taken out your video, please contact me.
- Лайк и подписка на канал очень сильно
поможет нам в развитии =)
- МЫ ВКОНТАКТЕ: http://vk.com/club32718932
Музыка: KLIM beats - Place for us (http://klimbeats.bandcamp.com)
Dodge Ram 4.7L Air Intake System
www.CGSIntakes.com This is a Dodge Ram 4.7L with a CGS Cold Air Intake
System installed. As you can see and hear this performance Cat-Back Exhaust System is very quiet on the inside and
outside. This system can gain up to 13hp to the rear wheels.
2005 Dodge Ram 1500 4.7L
Black 20" XD 797 Spy Wheels Nitto Terra Grappler Tires, Leveling kit, Black
Vertical Grill, Black Halo Pojector Headlights, Led Fog lights, Super 40
Series Flow master Y-Piped.
Installation of a 6 inch lift from Top Gun Customz on a 2012 Dodge Ram 3500
Like us on Facebook @: https://www.facebook.com/BlinkAutomotive
This is an installation video of a 6" Lift from Top Gun Customz, This is on
a 2012 Dodge Ram 3500.
This video is for entertainment purposes only. Please read all of your
instructions for your specific lift.
Music by: Kevin MacLeod @ INCOMPETECH.com