Plastidip Taillight Tint Stencil Diy
Here are the answers to most of your questions....
1. Will it come off?
No it's not permanent but YES it is resilient. I had it on my lights for
months with out it getting scratched or peeling.
2. Is this regular or smoke Plastidip
It is regular. I do say this in the video, however I should have put it in
the description. Sorry for the confusion.
3. Is that Forza Music? What kind of car is that?
Yes it is! :) Makes for great ambient music. Also, it's a BMW 335xi. It's
my winter car. (thus the whole "it's cold right now" in the video)
4. Yes it IS illegal.
At least where I live. HOWEVER, no I didn't get pulled over once for it. I
got pulled over for speeding and the cop didn't even mention it. I really
think it just depends on the cop that is behind you and how he feels about
5. isn't it too dark? Aren't you worried about people not being able to see
your lights when you brake? etc.
No, in the video they might look KIND OF dim, but in person the light
output was barely changed. HOWEVER, that doesn't mean that it wont be on
your car. It depends on what kind of bulbs you have, HOW MANY COATS YOU
DID, and just in general how nice your lights are. Either way, it was not
an issue with me and not once did I get the impression that someone
couldn't see them. Plastidip IS very transparent if you do a few light
coats... you literally JUST watched proof that it is... lol
6. Why didn't you use film? or why didn't you use "night shade"?
First off, I didn't use night shade because until I read these comments I
hadn't ever heard of it.
Second, I didn't use film because the other sets of film that i've used
either didn't fit right, were a pain to take off, peeled up on the edges,
and were much more expensive than this DIY.
7. Why did you use masking tape instead of electrical tape, duct tape etc.
Because masking tape leaves ZERO residue. Duct tape and electrical tape can
both leave lots of residue. As I stated in the Video though, you can always
use flexible nylon/ straight line tape I believe for round edges.
8. Why didn't you just mask everything BUT the clear part then blah blah
really?... mask the part that I WANTED to paint?....
A. that would have taken forever
B. it would have used WAY more paint.
C. I would NEVER mask everything then use a razor on my tail lights....
thats just silly.
9. What was the point of the "press and seal"
The point of that was to show you another way that I had seen it done. I
then went on to say how I do not reccomend it cause you would get garbage
10. How many coats did you do?
If you watch the video I technically did 1 coat. it was a thick coat but I
did that because I knew I wasn't going to be laying it on to the point that
it was not transparent. you will have to be the judge on how many
coats/passes you do. Good news is, if you put on too much, or too little,
no worries! It's plastidip and it'll come right off! Than do it again!
11. Could you do this on your headlights?
I guess you could... although I could see that being a much easier way to
get pulled over. But really, it's worth a try. Worst case is you tell the
cop that pulls you over that you didn't realize it was illegal and ask him
if he'll give you the opportunity to peel it off on the spot.
12. Do you feel the edges with your hands?
You can if you rub your hand over it, but it's very faint. And no it did
not make it peel.
Really at the end of the day, Like I said in the video. Its not everyones
style. It's non permanent, it's SUPER cheap, and most of all THIS MAINLY
WAS A TEST AND A GUIDE ON HOW TO STENCIL YOUR TAIL LIGHTS not REALLY how to
plastidip your lights. So use whatever product you want. I just used
regular dip cause I had some lying around from doing window trim.
And like most mods to your car, you're doing this at your own discretion,
so be safe and use common sense. if you "black out" your lights, you may be
running the risk of accident. So only go to the point that they are still
Thanks for all the thumbs up, and all the kind comments. Hopefully this
answered most of your questions.
ZR1 Vette vs Jet! - Chevrolet Corvette ZR1 Races A U.S. Navy Fighter Jet
MT Editor at Large Arthur St. Antoine pits Chevy's awesome "Blue Devil" --
the Corvette ZR1 -- against its toughest adversary yet: a Blue Angels
F/A-18 Hornet fighter jet.
Shot By: Jim Gleason & Terren Lin
Edited By: Jim Gleason
Read the story here:
2015 Chevrolet Colorado - Exterior and Interior Walkaround - Debut at 2013 LA Auto Show
Welcome to AutoMotoTube!!! On our channel we upload every day short,
(2-5min) walkaround videos of Cars and Motorcycles. Our coverage is from
Auto and Moto shows in North America and Europe - We visit different shows:
Big, like Frankfurt, New York, Detroit, Los Angeles or Paris Auto Show, to
small regional, Classic Car, RV and Boat Shows.
We have thousands of High Definition videos of different types of vehicles,
everything from new, concept cars, super cars, classic, vintage, old cars,
hot rods, motorbikes, recreational vehicles, motor boats, sailing yachts,
to airplanes, bicycles, and even tractors :-)
In most of our videos, we take a look at the exterior design and interior
arrangements of the vehicle, so you can receive a general idea and
appreciation of a certain brand or model.
We really appreciate all your comments and critics - they help a lot, in
building one of the most diversified Auto & Vehicles Channel on YouTube!!!
P.S: To find a video of a certain model in our channel, just write the
brand and model name in the search bar above, or have a look in our
You can find us on our official facebook, twitter and google+ pages:
, or if you have chance, check out our web site:
http://www.automototube.net - there we have our videos, some pictures and
wallpapers, organized and all the vehicles easy to find.
Subscription link for our Channel:
Thanks for watching and stay tuned!!! A lot more to come...
Chevrolet Cobalt Тест-драйв.Anton Avtoman.
Цены и комплектации http://chevrolet.tts.ru/cars/cobalt/
https://vk.com/antonavtoman Добавляйтесь в друзья!)
Ещё автомобили B класса
Chevrolet Cobalt Тест-драйв.Anton Avtoman.
АнтИ-Тестдрайв: Chevrolet Cruze 1.8 141л.с.
Другие видео канала TheWikiHow
Chevrolet Cruze — глобальный проект General Motors,
созданный под руководством Тевана Кима,
пришёл на смену не связанных между собой
Chevrolet Cobalt и Chevrolet Lacetti. В основу автомобиля
легла новая глобальная платформа Delta II,
на которой построен Opel Astra J. Впервые
представленный в 2008 году для рынка Южной
Кореи как Daewoo Lacetti Premiere, он заменил собой
одноимённый автомобиль, продаваемый с 2003
года. Предыдущее поколение Lacetti
продавалось на рынках Азии, Европы и
Океании. GM заменил предыдущее поколение
на новый Cruze в течение 2009 года.
Австралийская версия продается под
маркой Holden Cruze со второго квартала 2009
года. Американский Chevrolet Cobalt заменён с
августа 2010 года и по прошествии года
Chevrolet Cruze твёрдо удерживает первое место
на рынке США среди компактных моделей.
В России производство налажено на заводе
GM в Шушарах (Санкт-Петербург). В продажу
на Российском рынке модель запущена
осенью 2009 года, ранее Chevrolet планировала
запустить производство Chevrolet Cruze в России
весной, но финансовый кризис внёс
коррективы в эти планы. По состоянию на
декабрь 2012 года стоимость автомобилей в
зависимости от комплектации составляет
от 599 000 до 817 000 рублей.
SPECDTUNING INSTALLATION VIDEO: 2004 - 2011 CHEVY COLORADO GMC CANYON BUMPER LIGHTS
SPECDTUNING is proudly recognized as pioneers in the automotive industry
for products and service. Our main goal is to provide the highest quality
products at the lowest prices imaginable. The SPECDTUNING warehouse is the
largest in Southern California carrying an array of aftermarket products.
With a wide range listing from: Projector Headlights, L.E.D. Tail Lights,
Third Brake Lights, Bumper Lights, Corner Lights, Front Grills, Bumper
Lips, down to Headers. These are just a few items mentioned from the
selection available. Furthermore, all the products are updated constantly
keeping SPECDTUNING ahead in the industry for all makes and models of
vehicles. Always prepared to serve every guest; please visit us at
SpecDtuning.com for more info or call 909-839-2533 to start a wholesale
account today or visit us at www.specdtuning.com. Staff at SpecDtuning are
here and ready to help.
2010-13 Camaro Fog Light DIY Halo Installation by Advanced Automotive Concepts
DIY Installation Guide demonstrating how to install fog light halos from
AAC into a set of 2010-13 Chevrolet Camaro Factory Fog Lights. This
is the same process for most late model fog light halo installations. This
video is intended to be a reference guide please read your included
instructions for more details and information. If you have any questions
please call 1(800)407-5776.
Electrical Troubleshooting Basics - EricTheCarGuy
Electrical Troubleshooting Basics - EricTheCarGuy
I get a lot of questions regarding electrical issues so when this 1994 Geo
came in I thought it might be a perfect opportunity to show some of the
basic steps that I follow when confronted with an electrical problem. Keep
in mind that electrical problems come in all shapes and sizes so there
really is no 'magic bullet' here but if you follow a basic procedure like
the one shown in this video it might help you find and repair the problem.
Here is a video that I did some time ago on soldering wires.
Visit me at: http://www.ericthecarguy.com/
Click below and Stay Dirty
Visit me at EricTheCarGuy.com
Visit EricTheCarGuy Forum
Visit my Facebook Page:
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.
How To Smoke Tail Lights Yourself
How To Smoke Tail Lights Blog:
Learn More! Check out our AMAZING VIP Auto Body & Paint Community Here:
In this short video we'll show you how easy it really is... How to smoke
tail lights yourself.
Basically, all you have to do is sand your plastic lenses with 1500-2000
grit sand paper. Preferably wet sand.
You'd just get a better cut with wet sanding. Now, some say you need a
adhesive promoter... I think it's a bunch of crap. As long as you sand your
lens, you wont need it.
Connect on Facebook for More FREE Updates:
Connect on Google Plus: https://plus.google.com/105353659833960525090/about
See What Our VIP Training & Community Can Do For You:
Get A Free 85 Page Auto Body & Paint Manual Here:
2010 Camaro Custom Oracle Blue LED Halo Lighting by AAC
2010 Camaro 2SS/RS 6.2L
LS3 426hp engine. Datmobile gets Super Bowl XLIV Rings. Custom Oracle LED
Package from Advanced Automotive Concepts. aacstyle.com or coming soon Camarolighting.com. Blue
LED Headlight Halo Rings behind Factory Halos, Blue LED Fog Light Rings,
P13 White LED Fog Bulbs, Blue LED Interior Light, Blue LED Pod Footwell
Lighting, Blue LED Trunk Light, 20 Blue LED Pods 360 Degrees Under Car,
White 3-Chip LED License Plate Lighting, Chevy Red LED Inlluminated Bowtie
with Dual Intensity Brake Light, Red LED Afterburner Tail Light Halo Kit,
Remote Control System with Dimmer, Stobe, and Sweep Functions
CCFL Angel Eyes Halo Fog Light Dodge Ram
CCFL Angel Eyes/ Halo Fog lights on my Dodge Ram 1500
I only keep 2 sets on hand: LINK BELOW
SEARCH EBAY: 151160822499
If you want to purchase CCFL ring replacement kit , please visit my eBay
SEARCH EBAY: 151158896193