Bagged Colorado for sale or trade
2005 Bagged Colorado
08 Colorado laying out
My new suspension
Chevrolet Colorado Prerunner Build - Raptor Offroad - Insane Project!!
Insane build project of a 2015 Chevy Colorado Prerunner. Specs: 2015 Chevrolet Colorado - 730hp Wegner Dry Sump LS7 with FAST intake - 4L80E trans - Currie Full floater rear with 9" - C&R Radiator - Full custom built Roadster Shop chassis and long travel suspension - 22" front and 27" rear travel - J-arm style front and 4-link style rear - 4130 front arms, spindles and trailing arms - Fox racing 2.5"dia coils and 3.5" series bypass with 2.5 bumpstops - Ultra 103 rims with 37x12.5R17 BF Goodrich Baja T/A KR - Wilwood 6 piston front and rear brakes RS says it took the “no comprises” statement seriously, and it shows. Gone is the original engine sitting under the hood and, instead, a dry-sump 7.0-liter LS7 V8 engine making 730 hp is powering this bad boy, paired to a 4L80E transmission. But, the concept doesn’t rely on the fact this is most likely the only LS7-powered Chevy Colorado in existence. The tuning shop has crafted a full-blown custom suspension for the 2015 Colorado Prerunner with 22-inch front and 27-inch rear travel, and a Curie Full floater nine-inch rear end. As if all of that custom work isn’t enough, the 2015 Colorado Prerunner benefits from 4130 front arms, spindles and trailing arms, Fox racing 2.5-inch diameter coils and 3.5-inch series bypass with 2.5-inch bump-stops and Wilwood six-piston front and rear brakes. Finally, a set of massive BF Goodrich Baja T/A KR tires provide the means to take the 2015 Colorado Prerunner anywhere. Truck was built by: Roadster Shop 28775 N. Rte 83 Mundelein, IL 60060
Installation of Air Lift Ride Control Air Helper Springs on a 2006 Chevrolet Colorado - etrailer.com
http://www.etrailer.com/susp-2006_Chevrolet_Colorado.htm Today on our 2006 Chevrolet Colorado, we'll install the air lift, ride control air helper strings, Part Number AL59539. Our first step, we'll be assembling the air sleeve, an upper and lower brackets. We'll take the air sleeve, install the upper bracket on top, going over the nipple coming out of the air sleeve. We'll secure the upper brackets to the air sleeve with the plastic nut provided, then we'll take our air fitting, the 90 degree fitting and thread it on top of the air sleeve. We'll go ahead and secure it, and tighten it down with a wrench. Next, we'll go ahead and install the lower bracket. Note: Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.