1988 Mazda 323 GTX first Drive
Ok, I did drive it out of the garage, but other than that, this is the fiirst time this car has moved with the new (to me) engine and tranny, or at all under its own power in a long, long time. I kept it short, since it has no Exhaust, and the tag is expired...
bf mazda 323 b6t turbo
b6t 288fwhp 20psi
fully balanced and ground crank
ACL race bearings
ARP main bolts
carrillo H beam rods
wiseco forged pistons 40thou
wiseco metal head gasket
ARP head studs
ported and polished head 3angle valve
custom ground cam shafts
custom cam gears
gates timing belt
microtech LT10s ecu with X4 ignition
4x bosch coils
EBoost2 Boost controler
bosch 044 fuel pump
magnafuel 2port fuel regulator
5 gallon fuel cell
Garrett gt2876r turboturbosmart 48mm progate
custom steam pipe manifold
aluminum radiator and custom overflow tank
hks blow off valve
3" Intercooler stainless piping
cork sport oil pump
new water pump
new timing pulley kit
ceramic coated turbo housings, manifold, inlet manifold, fuel rail+ hard line.
gear box has had a full rebuild with straight cut 3rd gear twin syncros
Mazda 323F / Astina Turbo
Mazda 323F / Astina turbo. Custom built BPT engine. Tilton clutch 1250nm, Precision 5862 , JE pistons, SPM rods, 3,5" Exhaust. Toyota GT4 trans
For more information visit: http://www.garaget.org/?car=4480
New vids coming up during 2012!
mazda 323f 1.8 dohc turbo
First ever Dyno run of my 323f. Results are not impressive, but they are good for current setup. Final result - 165 Hp, 195 Nm. Garrett T25 incoming, aiming for something in 200 Hp zone :)
1.8 dohc (BP) - 89-94 naturally aspirated.
Compression ratio - 9.2
turbo - IHI VJ11 (stock Ford Probe turbo)
ECU - stock GTX ecu
Exhaust and Intake manifold - stock GTX (BPT)
Ignition - retarded just to be on the safe side :)
More - http://www.323f.lt/forum/viewtopic.php?t=10686
Mazda 323 turbo 1.8 turbo
Thise video was recorded with a i phone 4s, mazda home made by me, megasquirt v3, mazda miata turbo manifol custome made, blue racing timing belt, full gasket kit,250 walbro fuel pump,400 cc injectors, thick honda de el sol radiador, turbo hybrid t03 t04, 38mm waste gate, and lots of extras am still working on it but it takes time and lots of money when you work on your own,..
88 Mazda 323 GTX (AWD Turbo) playing around Openheader
this is me taping in my friend's 323 GTX when we took off his cat for the night to see how loud it is open header... pretty fun, and my brother was in the back seat being really smart while kinda drunk, so thats funny too.