67 Karmann Ghia Viper V-10 "Blue Mamba"
A 1967 Karmann Ghia with a Viper V-10 motor in it that I shot at the
Detroit AutoRama 2013.....this is one cool Volkswagen...Make sure you
subscribe so that you don't miss any of the other cool cars I shot at this
Hear it run https://www.youtube.com/watch?v=NTvzfOzxsdI
Apparel Provided By:
Check them out!!
1967 Karmann Ghia V-10 "Blue Mamba" Running SEMA 2013
A 1967 Karmann Ghia the has a Viper V-10 transplanted into it...I first
shot this car at Detroit Autorama 2013...but I was not able to get a clip
of it running....At SEMA 2013 I was able to get this short clip of it
running....very cool....Check it out!!!...Make sure you follow me so that
you don't miss any of the other awesome videos I shot at this show!!
Feature shot at Autorama 2013 https://www.youtube.com/watch?v=5jDQvDUIbGs
My apparel provided by:
Check them out!!
1966 Volkswagen Karmann Ghia Restoration
This is a 1966 Volkswagen Karmann Ghia I recently did the finish body work
and paint on. The sheetmetal replacement was performed by Kelly "Metwiz"
Brown. Color is Porsche Guards Red. The car is going back to the owner for
re-assembly. Music by The Wind-Ups.
1969 Karmann Ghia
A 1969 Karmann Ghia that is Knox County Mayor Tim Burchett's first car...he
wrecked it..let it set and rust...than restored it to as good as new 20
years later...a very cool car...guy...and story...I am very honored to be
able to bring it to you..Check it out!!
Lowering the rear of a Volkswagen Karmann Ghia suspension
This video takes a more comprehensive look and demonstrates the lowering
and fine-tuning of the swing axle rear suspensions. Simply put, if your car
is either lowered or raised and you are not driving on Drop Plates or Raise
Plates then you are settling for an inferior and potentially dangerous
ride! Lower or raise the rear of both Swing Axle and IRS Volkswagens and
Buggies without changing the factory spring plate travel or torsion in the
system and achieve a superior ride! Atomwerk Drop/Raise Plates will restore
the factory "feel"! We did not seat-of-the-pants design our Drop Plates to
lower your vehicle, we ENGINEERED them so that your car will not lose its
ride quality after it has been lowered. Bottom line is that Drop Plates are
the only way to have a comfortable ride when your rear end is lowered. See
our tech page for greater understanding of this:
Lower your VW the right way!
Check out our products at www.atomwerk.org
Call us at 541-935-8026
Video editing: Blue Dot Productions
Music by: Abrasion Equation
Label: Specops Music
all rights Specops Music
1971 Volkswagen Karmann Ghia Engine Start
First time starting up the 2333 cc engine (91x84mm) that I installed in my
wife's freshly restored 1971 Volkswagen Karmann Ghia convertible. Yes, I
know my coil is installed upside-down. The after-market wire harness was
installed with too little slack to reach a downward-pointing coil. This is
68 VW Karmann Ghia WRX Cruising
Another test run...at 12psi. both of the little runs in the vid are
slightly uphill with some short shifts (I'm no racer) but you get the
picture. speedo marks are at the 20,40,60,80,100mph.
World smallest V12 engine
Apparently the builder's name is Yesus Wilder and he only used three
materials to build the engine. Stainless steel, aluminum, and bronze.
All credits to him.
Holley LS Fest 2010 Awesome Karmman Ghia
This car was built by a gentleman, shown and tracked at Holley LS Fest
2010. It won Best in Show and the Engineering award and no one at the show
disagreed. Watch the video to see the most awesome Carman Ghia in the