94-97 Honda Accord Muffler Replacement
In this video I show you how to replace a damaged muffler on 1994-1997
Honda Exhaust self locking flange nuts
part number 90212-671-005.
Some models will have spring bolts and donut gaskets instead of the crush
gaskets and flange nuts this California emission model Accord had. But the
replacement process is the same.
You can reuse the donut gaskets in most cases and the spring bolts can also
be reused. The flanges WON'T come together when the spring bolts are fully
tightened. Just tighten the spring bolts until the shoulder on them is
flush with the flange. The springs handle the compression of the gasket.
Inside the old muffler:
Intro and outro music Welcome To The Show by Kevin Macleod
Due to factors beyond the control of Bushougoma, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. Bushougoma assumes no liability for property damage or
injury incurred as a result of any of the information contained in this
video. Bushougoma recommends safe practices when working with the tools or
equipment seen or implied in this video. No information contained in this
video shall create any express or implied warranty or guarantee of any
particular result. Any injury, damage or loss that may result from improper
use of these tools, equipment, or the information contained in this video
is the sole responsibility of the user and not Bushougoma.
2003 Accord Megan Racing M-VO Exhaust
A short clip of my 2003 accord with a Custom Catback Exhaust.
The piping is 2 1/4 with one 12in "Bullet" resonator to a Megan Racing M-VO
muffler. My other supporting mod is a Weapon R Short Ram Intake
Shot with an Iphone4.
-The video is for reference for anyone interested the M-VO muffler
How To Pull Honda Codes Without a Scanner -EricTheCarGuy
Link to code explanations:
Honda ABS Codes 1994-1997:
Honda ABS Codes 1998 and up:
Visit me at: http://www.ericthecarguy.com/
Discussion about this Video:
I feel like I should have made this video a while ago but the opportunity
never came up. Since I had this RL in my shop that had a check engine
light AND an ABS light I thought it was a perfect opportunity to put this
video together. I get asked all the time about my 'special tool' and it's
really nothing more than a Honda 2 pin connector with the input wires
soldered together. These connectors might be harder to find than you think
but if you run across a junk honda and one of these is on the harness grab
it. Even if you don't have the tool a paper clip or piece of wire will do
the exact same thing so don't sweat it if you don't have the tool because
shorting the connector is all you need to do.
I hope you find this video helpful.
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee
against unauthorized modifications of this information, or improper use of
this information. EricTheCarGuy assumes no liability for property damage
or injury incurred as a result of any of the information contained in this
video. EricTheCarGuy recommends safe practices when working with power
tools, automotive lifts, lifting tools, jack stands, electrical equipment,
blunt instruments, chemicals, lubricants, or any other tools or equipment
seen or implied in this video. Due to factors beyond the control of
EricTheCarGuy, no information contained in this video shall create any
express or implied warranty or guarantee of any particular result. Any
injury, damage or loss that may result from improper use of these tools,
equipment, or the information contained in this video is the sole
responsibility of the user and not EricTheCarGuy.
2004 Honda Accord Flowmaster
This is my 2004 Honda Accord V6 6 SPD with 2.5 inch pipes from the Cat
back. And at the end I've got some Flowmaster 40's.
Muffler-less 1992 Accord EX
The muffler of my 1992 Honda Accord fell off the other day. So, I made a
short video of some clips while driving around with no muffler. The're no
fart can here folks, just a stock Exhaust without a muffler on the end.
PS - This car is pretty much stock, including the original F22A6 2.2L I4
Honda Accord cb7 1993 Flowmaster muffler, test pipe and tip
Sincé there arent a lot of videos of cb7s cruising with a nice sounding
Deep tone, I decided to upload mine. Stock piping, flowmaster muffler 40
series (installed today), cherry bomb tip, and a test pipe. Looking forward
to swap to 2.5 inch piping and a high flow cat.
P.S Use headphones so you can enjoy the Deep tone.
Saudi Auto - 2015 Honda Accord Test Drive - سعودي أوتو- هوندا أكورد موديل 2015 تجربة تفصيلية
زوروا موقعنا للحصول على المزيد من
التفاصيل : http://www.saudiauto.com.sa
تجربة تفصيلية لـ هوندا أكورد موديل 2015
تشمل شرح تفصيلي لكل التعديلات والتغييرات
التي حصلت عليها، وهي تتوفر في أسواقنا
بمحرك أربع أسطوانات سعة 2،4 ليتر بقوة 185
حصانا، يعمل مع ناقل حركة آلي CVT متعدد
السرعات، كما يتوفر لها محرك V6 سعة 3،5
ليترات يولد 274 حصانا، يعمل مع ناقل حركة
آلي 6 سرعات.
Detailed Test Drive for the Honda Accord 2015 model. It include detailed
walk around the facelift and the changes been done to the new Accord. It's
available in our market with 4 Cylinder engine with 2.4L which deliver 185
hp, with Automatic Transmission CVT. Also, it comes with V6 engine with 3.5
L which deliver 274 hp.
Honda Accord VTEC timing belt and water pump Honda Accord VTEC High Detail How to
You can buy a quality belt and water pump online here
Special thanks to Spanky for filming this video for me. : ) My last
Honda Accord video was
very well viewed, but lacking in good sound, stability, and lighting so I
did another one with some help. Enjoy High Detail How to do a timing belt
and water pump Honda Accord VTEC
2014 Honda Accord vs Toyota Camry 0-60 MPH Hybrid Matchup Review
( http://www.TFLcar.com ) The 2014 Honda Accord Hybrid and the 2014 Toyota
Camry Hybrid directly compete against each other for new car hybrid sedan
Click link for all of the Kickstarter details ( http://kck.st/19SN7KF )
So which of these two fuel sipping sedans is the better buy. In another
accurate fun and informative TFLcar 0-60 MPG video review Nathan and Roman
put both hybrid up against each other to not only see which is the most
fuel efficient, but which one is the fastest.
Check us out on:
Facebook: ( https://www.facebook.com/tflcar )
Twitter: ( https://www.twitter.com/tflcar )
and now even Truck Videos on YouTube at:
The Fast Lane Truck ( http://www.youtube.com/user/tflcar )
1991 Honda Accord F22A1 2 1/4" turbo muffler exhaust
1991 Honda Accord LX wagon (CB9) F22A1 with 2 1/4" Exhaust after the cat, no resonator, turbo muffler. Stock Exhaust manifold and cat. Aftermarket intake
Yes, she had a slight miss at start-up. The car has 272,000 on the clock
and I'm not too concerned as it's not always there.
This is just a temporary Exhaust, the
old Exhaust looked like somebody fired
buckshot down the inside of the length of the pipe. A Magnaflow will be
replacing the turbo muffler before too
long. Figured it's been a while since I've made an Exhaust video with any of my cars.
2014 Honda Accord Sport Manual - WR TV POV Test Drive
For the best video experience, we encourage you to wear headphones or
earbuds. The audio in this video was recorded with in-ear binaural
microphones. Because these microphones record sound from inside the ear,
playing the sound through headphones gives the sensation of 3D sound. All
of this translates to a very realistic listening experience.
If you haven't already, subscribe to our channel! We post new car videos
like this every week.
WINDING ROAD RACING is here, carrying the gear you need to go faster.
2015 Honda Accord EXL POV Review
This is the 2015 Honda Accord EXL brought to you by Grainger Honda. This
POV review will cover a majority of content on the 2015 Accord including
pairing a phone, making a phone call, using google maps, using the
bluetooth, streaming music, importing phone contacts, the back up camera,
lane watch, and tons more! visit us at www.graingerhonda.com
Flowmaster Muffler Comparison
A raw test of 7 different Flowmaster mufflers on one motor.
The Motor -
Small Block Chevy 406, 11:1 compression, Crane Solid Roller Camshaft,
Brodix heads with 2.05- 1.60 titanium valves, Eagle 4340 Crank, Eagle H
beam Rods, Manley Forged pistons, Victor Jr Intake manifold, 850 Holley DP,
K&N air filter, Moroso 7 qt. pan, 1 7/8 headers, BE COOL radiator with dual
13 inch fans, MSD distributor, MSD coil and MSD 6AL box.
Exhaust - Flowmaster 3 inch Scavenger