EPIC DRIFTING FAIL COMPILATION!! # 2013
The first part of the drifting fails. Hope you guys enjoy!
So make sure you hit that subscribe button to never miss a video! Why not?
If your Video is in this Compilation please contact me to be credited for
it or have your part removed, thank you.
26 PSI RX-7 GT35R Single Turbo
Ever wonder what happens if you hit fuel cut at 26 PSI on a turbo RX-7? Watch me do it on accident while
For those wondering, I had the ECU set to 20 PSI expectation and wastegate
to 26 PSI. ECU will go 3.5 PSI over its limits before it cuts the fuel.
Small logical error can make a huge difference.
I got lucky. I attribute a large part of that to the pre turbo water injection keeping my knock low and
combustion temps low while tuning.
Why I picked the GT35R for my RX-7 over the stock twin turb
I cover the basics of turbochargers in
simple terms to explain why I chose the GT35R over T04Z or T78 or T88 etc.
It's all about air flow. Sure there are technologies that make the turbo more efficient in more applications but
the turbo is most efficient in an area
known as the compressor map.
Exhaust back pressure plays a huge
part when dealing with quick spool small turbos.
Large turbos deal with spool up and lag
I chose the GT35r for near stock spool up with more efficient 400 hp
Illegal RX-7 Street Race. Tokyo Japan.
This is off of an Option DVD I got a few years back. Rx-7s do a top speed
run on open freeway. Cannon ball run! Super illegal street race. Noticed
there wasn't a clip of it so I uploaded the whole thing. Pretty intense.
Hope you enjoy!
Link to video with just racing:
Part 12: 13B Rotary Engine Rebuild - My 76 Mazda RX-5 Cosmo Restoration
Just as I promised last episode, it is finally time to build the engine!
Part 12 of my RX-5 Cosmo restoration covers the entire process of building
the 6 port 13B Mazda rotary engine. While this engine is a hybrid of GSL-SE
RX-7 and Cosmo parts, the process is the same for any rotary from a 12A to
a 13B NA, 13B turbo, 13B-REW or any
other variant of the 13B. This video shows the whole process of the engine
build, starting from measuring the rotors and covering everything else
including clearancing the side seals, assembling the rotors, complete
assembly the short block, setting the eccentric shaft end play and
installing the front cover and everything underneath it. It's probably the
most complete engine build video outside of what you can buy from the
vendors, and as such, is an hour long. After this one, I'm going back to
videos under 20 minutes. But for now, grab a beverage of your choice, sit
back, and enjoy.
My GT35R RX-7 sounds sexy ran hard
I finally took my 1993 Mazda RX-7 out. Over winter I gutted the entire
engine bay etc. I installed a GT35R single turbo. The car is insane. Listen as I Boost to 10.5PSI.
It does NOT have a Blow Off Valve installed :-p