IKW. Budel Sprintfinale 2010
Film van de sprint Finale van de Kever Club Nederland op zondag 20 Juni
2010. Met verschillende kevers, busjes en een karmann
Episode 70 Part 2 Seamless floor pan installation, 1965--70 Mustang, Autorestomod
We finish the installation of the National Parts Depot Mustang floor pan in our weekend
project 1968 Mustang
hardtop! In this episode we only replace the sections needed. Gary Jackson
shows how to cut, weld, and grind a pan for a seamless repair that will
give a factory look without using the full pan. This method will also be
easier due to less welding and grinding.
Sponsor: National Parts Depot
Classic VW Engine Rebuild, By Last Chance Auto Restore.com
We began with a dual port 1600 cc engine from a 1973 Volkswagen Beetle.
The engine ran with a miss and was smoking a bit . After performing a
compression test,(both wet and dry) , we determined the crankshaft and
bearings were fine.
We replaced the pistons, pots & rings. We had the valves redone and made
several upgrades along the way.....
1966 Volkswagen Karmann Ghia Restoration
This is a 1966 Volkswagen Karmann Ghia I recently did the finish body work
and paint on. The sheetmetal replacement was performed by Kelly "Metwiz"
Brown. Color is Porsche Guards Red. The car is going back to the owner for
re-assembly. Music by The Wind-Ups.
67 Karmann Ghia Viper V-10 "Blue Mamba"
A 1967 Karmann Ghia with a Viper V-10 motor in it that I shot at the
Detroit AutoRama 2013.....this is one cool Volkswagen...Make sure you
subscribe so that you don't miss any of the other cool cars I shot at this
Hear it run https://www.youtube.com/watch?v=NTvzfOzxsdI
Apparel Provided By:
Check them out!!
Air-Cooled VW Beetle Complete Engine Rebuild
It's here. It's ready. Volume 3 is a complete engine rebuild video on a
1600 dual port, 1500, and 40 hp motors and all the important differences.
(Full 158 min video available at www.mamotorworks.com part #323-303) This 2
hr. 38-min video includes complete tear down, Inspection, and reassemble.
If you've been hesitant to tackle something this big this video gives you
not only all the information but the confidence and support you need to do
the job right. Rick and his two sons will walk you through the whole
process in an orderly way starting from the motor just as it comes out of
the car to a completed running motor ready to be installed. You'll feel as
though you're next to Rick and he's you're personal friend, sharing trade
secrets that he's picked up in over 35 years of experience exclusively on
air cooled VW motors.
2 hours 38 min. of easy to follow instruction, Including:
1971 Volkswagen Karmann Ghia Engine Start
First time starting up the 2333 cc engine (91x84mm) that I installed in my
wife's freshly restored 1971 Volkswagen Karmann Ghia convertible. Yes, I
know my coil is installed upside-down. The after-market wire harness was
installed with too little slack to reach a downward-pointing coil. This is