H22 accord first gear pull
h22 accord, f22 trans. I/H/E 10.6:1 compression ratio chipped p28 first
gear pull. the noise in the beginning is not the car, its the camera
hitting the steering wheel as it turned.
Honda Accord VS Lamborghini Murcielago. EXOTIC CARs RACING, TOUGE FUN!!
found a pack of Exotic cars meeting up, so i sayed.. hmmm this could be
so i joined in with my little Gas Saving Honda to race these high end
Performance Cars!! XD
good racing and fun! too bad there was so many cars that the racing was
very limited.. =/
and if you may ask about my car, its;
naturally aspirated (all motor) Frankenstein H/F series putting out 234whp
built by myself (", )
end of the video: the whole pack of cars cruising by.
1994 Accord 0-60
NO RUDE OR VULGAR COMMENTS PLEASE! LEAVE ALONE IF YOU DON'T LIKE IT
8.0-8.2 sec 0-60 time on a 1994 honda accord ex coupe with short ram
intake, 4-2-1 header, and catback Exhaust. Manual trans too. stock 0-60 on clutch
drop is 9.2sec. damn i can drive my car although i burned my clutch a tad
P2646 Honda Accord ,VTC strainer
P2646 Honda Accord ,VTC strainer. This Honda would not run at higher
speeds. It would start bucking and stall out if held to the floor. After a
bit of cleaning it seems to run fine. Do not try just removing the screens.
If you try to run a Honda with out the VTC strainer any dirt that the
screen would of caught will now go in to the little oil passages and be
hard to remove. I am also Leary of trying to add cleaners to the engine
when experiencing VTC Strainer problems.If the debris stuck in the VTC
Strainer bad enough to set a P2646 code then I would be afraid the debris
would break down smaller ,get through the VTC strainer just to get caught
up in the valve train oil passages.
AFAccord's F23 Turbo Accord - HD Vids and Dyno
I only had a week to drive the car after it was tuned and wasn't able to
wire up my ECU switch in time to get any high Boost runs on video. Sorry guys! I'll make
plenty of high-Boost videos when I
come home, so subscribe!
Music rights belong to Gemini - Graduation of AEI Media.
Parts and Specs:
-F23 block, bored to 86.5mm
-Wiseco K20 spec pistons @ 10.5:1 compression
-SwainTech ceramic coating on piston crowns
-Crower F23 rods
-OEM main bearings (pink across all journals)
-ACL HX rod bearings
-Kaizenspeed balance shaft delete kit
-Bisimoto heat-shielding intake manifold gasket
-Bisimoto Pro valve springs
-Bisimoto Pro valve retainers
-Bisimoto cam gear
-Innovative 65A engine mounts
-Maxbore F23 throttle body
-MFactory limited slip differential
-DIY ramhorn turbo manifold
-DIY 2.5" charge piping from CXRacing
-28"x8"x3.5" FMIC from Go-Autoworks
-Triple-core half-size radiator from Go-Autoworks
-3" Straight pipe Exhaust
-3" Vibrant Flat black muffler
-Garrett T3/T4 57 trim turbo
-ACT Xtreme pressure plate
-ACT Streetlite flywheel
-ACT performance street disc
-Tial 38mm wastegate
-Tial Q BOV
-P61 OBD1 ECU
-Tuned using eCtune by the infamous... Joseph Davis!