Nitrous Lawnmower Dyno, Ram Air Trans Am Dyno FUNNY

Here's a look at the recent installation of the DynoJet Dyno at East Texas Muscle Cars in Longview TX. Keep in mind, it's VERY late at night when we finish the install, so everybody is goofy and glad to have it finished! Be sure to check us out on Facebook at Triple-X Motorsports & Outdoors for all the latest updates! http://www.facebook.com/pages/Triple-X-Motorsports-Outdoors-RekjavicXXX/143751552330968

More Videos...


Big block chevy lawnmower road test
Check out some of my other videos: https://www.youtube.com/watch?v=XCKnch1MgqM https://www.youtube.com/watch?v=1ibqs22oQc4





turbo charged lawnmower
turbo charged tractor/lawnmower





Cub Cadet V8 Trophy.Winner
Paul Jones dropped an alcohol-fuel Ford 351 Cleveland V8 running 15:1 CR into his Cub Cadet riding mower. And why not? It fits, doesn't it? Built for pulling contests, but also handy when you need the lawn done and you don't have a lot of time. Just listen to that thing bark. Recorded at the Genesee Valley Antique Auto Club show on Aug 1, 2010 on the grounds of the Rochester (NY) Institute of Technology. For More, See: http://www.youtube.com/watch?v=wAjObHbOn9U Get your Professional High Gloss double sided-- ALKY CUB HERO CARDS 8.5x5.5. Price: $3.00 Free shipping. Mail Payment and shipping info. to PO Box 17951, Rochester, NY 14617. Also available for Special Events, Parades, Car Shows etc. Send request and info. to hydro351@rochester.rr.com





Pulley Swap Speed Test - Hot Rod Lawn Tractor - Racing Lawn Mower
Be sure to check us out on Facebook at: https://www.facebook.com/RamblinAroundTV I managed to get the pulley swap done yesterday and we took it out for a little test drive. I decided to leave the engine pulley stock and just swap the transaxle pulley. So, I switched the transaxle pulley from a 9 inch diameter pulley to a 2.5 inch pulley. Then I took up the slack in the old belt, to figure out what length the new belt should be. It turned out that a deck belt from a 40" Murray works just fine. We still have some carburetor issues to address before we'll be getting the maximum performance out of it. I also have some modifications that I'm going to make to the spindles and front end. I hope you find this racing mower project interesting...thanks for watching!




Follow