How to build HORSEPOWER - Ford 461ci Windsor V8 by Dandy Engines
Engine specialists Dandy Engines building a small block Windsor 461ci
stroker for Pat Staplton. Follow the engine assembly as the guys aim to
make more than 820hp naturally aspirated on regular pump unleaded 98-RON.
Pat plans on putting this brute of an engine into a Ford Falcon XD/XF Ute.
[ http://dandyengines.com ]
Creative Commons music license CC 3.0
Jahzzar - Breaking Bad
CAT Engine Teardown TimeLapse
This CAT diesel engine had a million miles on it and was in perfect
condition upon inspection. Sindall Transportation in New Holland, PA did
CNC Cylinder Head Repairs
15D CNC Ported Racer Pro Hd Repairs . These Hds are Australian designed .
They flow as good as any 15D hd and are a superb casting for modifying.
1909 Cadillac First Start in 79 Years
This 1909 Cadillac was stripped down into a speed car, raced and then
parked in 1934. I was acquired in the early 1960's for restoration. The
restoration was put on hold for many years and then re-started a few years
ago. After multple checks of the ignition and timing we finally achieved
the first start on July 28, 2012. There is still more to do to tune the
engine and sort it out for driving later this year.
The spray on the first try happened when we left the primer cups open. It
runs better with them closed.
And the owner did make it a bit easier by adding an electric starter to the
For more of the story see the HCCA Gazette, May - June 2009.
To see how things turned out, see the related video, 1909 Cadillac first
drive at http://www.youtube.com/watch?v=qEy0KagVrIw
First Engine Start FW190
FW190A-8 Werknummer 173056 quickly roared to life Sept. 21, 2009 after 8
1/2 years of restoration work on the four major components of 173056: Tail,
fuselage, wings and engine. Located at the Baton Rouge Metro Airport at PAI
Aero, this restoration is a project of Don and Linda Hansens engineering
company. The engine was started but shut down quickly as a precaution due
to lack of oil pressure indication - found later to be an incorrect
pressure sender. Major Frank Hohmann from Flug-Werk in Gammelsdorf, Germany
worked intently for most of September, as did Don Hansen and crew Rusty
Gautreaux, Danny Trogé and Stephen Hansen to complete engine rigging. This
de-preservation/pre-oiling run was a smoky success, with the 2000HP Ash82T
engine starting instantly on the first try after 30 years in storage. The
first flight is planned for Summer, 2010.