Twincharged GTP Running 12psi
My Twincharged GTP Running 12 psi (About 400hp) on the new engine and
tranny...... Not as strong as 17psi (500hp) but still feels good !!! This
is without the bypass valve. It's less laggy this way...
Pontiac Fiero 3800 Supercharged 0-120
Not quite standing still at start but ended at 120. Any slower and it just
spins the tires (245-50-16's)
This was all done on an empty road that leads nowhere. 5600ft elevation
-Car has been sold- It will be missed
Pontiac Trans Am (1407 PS) - GRIP - Folge 115 - RTL2
Der extremste Sportwagen der Welt: der auf 1407 PS aufgemotzte Pontiac
Trans Am des Norwegers Pal Arvid Blyt. Dieser versucht seine
Top-Speed-Bestmarke von 407,134 km/h zu knacken. Schafft er es?
Komplette Folgen GRIP bei RTL II NOW:
Alle Infos zur Sendung: http://www.rtl2.de/grip
GRIP bei Facebook: https://www.facebook.com/grip
GRIP bei YouTube abonnieren:
"GRIP - Das Motormagazin", immer sonntags um 18.00 Uhr im TV bei RTL2.
GTP Turbo runs10.93 @ 127.55 mph
10.9 run in full street weight (minus mufflers). Would have been a quicker
run if 3rd gear would have held (you can hear it switching between 2nd and
3rd...I also let off the gas at the 1/8th mile to try and make it shift,
and it ended up going into 4th for the rest of the run!)
2003 Mazda Front Wheel Bearing Replacement (Press In Type Bearing)
Wheel bearing replacement in a 2003 Mazda Protege 5. Press in style
bearings done without using a shop press. Specific for Mazda Protege, but
many of the techniques will apply to vehicles with pres-in-style wheel
It's a good idea to try to use the bearing-press-kit the way it was
intended. If the bearing doesn't budge, BE CAREFUL using a breaker bar. The
bolt supplied with the press-kit is not very strong...it with probably
shear off the head. Try to give the bearin a few hits with a sledge hammer
as seen in the vid..it will get the bearing moving. Then you can use the
press-kit, and it should finish pressing out the bearing.
Pressing in the bearing with the kit should be no problem.