Ford Capri RS 2600 Cosworth V6 dyno crash
See more at https://www.facebook.com/CapriRS2600
Partial throttle runs for fuel mapping. Dyno was set to sweep
1000-7000rpm in 18 seconds. Limiter at 6450rpm. Crash at 5400rpm most
likely due bad conrod bearing.
Highlights of season 2013:
Ford Capri 69' Brussels Motor Show
The unveiling of the new Ford Capri at the 1969 Brussels Motor Show,plus a
brief clip of Colin Chapman inspecting the production line of the Lotus
V8 Ford Capri...Launches off the line
A V8 Ford Capri launches from the start line of Stage 13 of the Tasmanian
Tarmac Challenge Rally October 2008.
Ford of South Africa assembled the Capri from 1970 to 1972 with a similar
model range to the UK. No facelift models or RS variants were marketed in
About 500 Capris were converted by specialist Basil Green Motors to run the
302 Ford Windsor V8 engine. These models were known as the Capri Perana and
were very successful in local touring car events, winning the 1970 South
African championship and, in a different format, the 1971 championship as
No Mk II and Mk III Capris were exported to, or built in South Africa.
Classic Ford magazine's 2.1 Ford Pinto engine build on HT Racing's dyno
Here's Classic Ford magazine's Project 2.1 Pinto being set-up and run-in on
the HT Racing Dyno by
HT's Aaron Tucker and Vulcan Engineering's Steve Curson. The engine went on
to make a corrected 161.7 bhp. For the full build-up, see the August,
September and Summer 2009 issues of Classic Ford.
Buy the mag: