Fender bottom rust repair
lower fender patch panel install, went in pretty smooth ,going to grind the backside up a little later,did clean the inside brace up and treat in with rust reformer and a good undercoating
how to make a panel butt - joint.
This video shows a technique for producing butt joins in car body panels.
Butt Welding Sheet Metal With A Mig Welder
If you are doing rust repair patches on your restoration project, I put together a few tips for you on how to avoid blowing holes through your seams: Use short bursts, pull the gun away from the work a bit to make a cooler weld, don't point the gun directly at the weld, hold it at an angle, weld on the last weld, that's the thickest piece of metal, use a copper backing plate to prevent fall out. Follow me on social media. Facebook - http://facebook.com/gregsgaragekc Twitter - http://twitter.com/steelsplinters Instagram - http://instagram.com/gregsgaragekc