Karmann Ghia sheet metal patch
Cutting, bending, and welding in a patch to smooth out a fresh air vent for
a 1974 Karmann Ghia. Includes some hammering, mig welding and a bit of the
english wheel. I have tons of pictures on my blog:
Karmann Ghia - Rotisserie Part 2
Car goes onto rotisserie for the first time! HELL YES!!! It gets REALLY
heavy at the bottom of the swing, but everything works perfectly. I need
to add a stop at the bottom of the swing so it rests on the fixture and not
the wheel wells.
68 VW Karmann Ghia WRX Cruising
Another test run...at 12psi. both of the little runs in the vid are
slightly uphill with some short shifts (I'm no racer) but you get the
picture. speedo marks are at the 20,40,60,80,100mph.
Dan's slammed Karmann Ghia The Video Volks
Dan Smith owns this beautiful slammed Ghia. A right hand drive UK model
dropped on Fuchs and running a narrowed beam.
Fully restored and on the road. Also currently for sale!
For a full write up on this car check out Airmighty.
Music by The Lock and Keys.
Produced, filmed and edited by PJ Gibbons
1969 karmann ghia restoration part 2
This is the second installment of my restoration. It covers engine install,
first turn over, some body work and interior work.......
Hope you enjoy it....
1967 Karmann Ghia V-10 "Blue Mamba" Running SEMA 2013
A 1967 Karmann Ghia the has a Viper V-10 transplanted into it...I first
shot this car at Detroit Autorama 2013...but I was not able to get a clip
of it running....At SEMA 2013 I was able to get this short clip of it
running....very cool....Check it out!!!...Make sure you follow me so that
you don't miss any of the other awesome videos I shot at this show!!
Feature shot at Autorama 2013 https://www.youtube.com/watch?v=5jDQvDUIbGs
My apparel provided by:
Check them out!!
1971 Volkswagen Karmann Ghia Engine Start
First time starting up the 2333 cc engine (91x84mm) that I installed in my
wife's freshly restored 1971 Volkswagen Karmann Ghia convertible. Yes, I
know my coil is installed upside-down. The after-market wire harness was
installed with too little slack to reach a downward-pointing coil. This is