"Moving from the City to the County"
After waiting for a welder for months, we finally got one. Using materials around the property and taking parts from an old mini bike, we put this riding machine together. We call it the "Tri-Kart". It is a simple design and easy to build.
Thanks for Watching :)
*Has Been Sold* Total build time less than 5 hours. It has a 43cc "gsmoon"
2-cycle engine with electric start. Built from a pile of parts.
350 v8 go cart first run burnout
This is in Kelowna BC CANADA
cookin off tires on our 5L
after this video we did weld rear end, put in a throttle pedal, a tach,
then jumped it, split the bell housing and blew it up :)
Three dog reverse trike motorized go kart test footage
This is a the first real test footage of the Three Dog reverse trike go
kart built from scratch. The only components that were sourced are the
Harbor Freight 6.5HP 200cc motor, the wheels, and front spindles.
Everything else was designed, engineered, and fabricated by D. Soetenga.
This reverse trike was built for a $350.00 budget and it only weighs 80lbs
total with a 34lbs motor. After these test runs some modifcations will be
made to the design.
Electric Homemade Wooden Go Kart Run 3
Hey guys this is Revision 3 of the electic go kart. It has a new Ramsey
winch motor and a 400amp curtis 1204-410 motor controller. The sprockets
have been upgraded to hold a #35 chain and the new size chain has been
added. I the motor specs: 8000RPM at 24v, 32 in pounds of torque, 45 amps
no load, 140 amps full load 6 hp continuous, 11 peak, running currently at
36v 85amps. Thanks for watching. Please leave your comments in the sectiob
below. Please note: this is not supposed to be professional looking or
super-functionalal for that metter, it wat meant to be a fun project.
Low budget go kart build + first test run
1-custom frame welded together
2-rear axle (22mm threaded steel shaft)
2- DIY rear axle bearings
3- full set of wheels from a kids pedal kart
4- hydraulic rear disk brake ( small dirt bike )
5- engine mounted ( 50cc 2-stroke scooter engine )
6- set up the throttle + brake pedals
it still needs some work
DIY Go-Kart Reverse Trike
Have a look at my latest project:
After a few weeks planning and building , It's finally finished. Check it
out. Have a look at my other videos, including my new project, the 'Hot Rod
Flamed Racer' go kart
Home Made GO KART from MONTALBAN RIZAL PHILLIPPINES
The time has come after a long time ive started to build and finish it with
my own knowledge and money,it was a hard project and cost me about 19 to 20
thousand pesos.It has a 2 stroke 50cc 2JA YAMAHA JOG engine and has a 14:13
spracket tooth ratio.