350 CHEVY ENGINE START UP ON GROUND * HOT RAT ROD ENGINE * REDNECK ENGINEERING

Starting up this 350 Chevy engine to make sure it is alright to install in a short bed '69 Chevy truck. The engine had sat for several yrs. Seems good to me.

More Videos...


383 Stroker First Start!
**See the engine in action here:** http://www.youtube.com/watch?v=fwQ26qRhfMM First start of my new 383 Stroker. This will be going into my 1980 vette. Here are the specs: 1988 350 hydraulic roller block. 4 bolt main, 1pc RMS. Bored .030 over. Eagle 383 stroker nodular cast crank, lightened and internally balanced Eagle forged 6" connecting rods Forged and coated Mahle flat top pistons 7qt Moroso pan kicked out for clearance. Moroso pump and pickup. Edelbrock 2204 cam lift .539/.548 duration 296/300 64cc Edelbrock Aluminum E-tec heads, 170cc int. Crane Cam Gold Race extruded full roller aluminum rocker arms 1.5 ratio Edelbrock hardened pushrods Edelbrock Rollin' Thunder hydraulic lifters Edelbrock RPM Air Gap intake HEI ignition MSD wires.... Headers to be determined... Final CR 11.0:1. Power expectations around 500hp/500tq





CHEVY 454 ENGINE START UP ON GROUND * HOT RATROD ENGINE * TEST RUN * REDNECK ENGINEERING
NO RIGHTS ARE IMPLIED TO THE MUSIC PLAYING......Just purchased this 454 Chevy engine. Had been sitting for 10 yrs. 86,000 actual miles on it. Switched to the electronic distributor and it started right up. Just needs a little more "cam" to make it sound better. OH, AND I FOUND OUT IT IS A 2-BOLT MAIN,MY BAD!!





How to start a Stand Alone Engine
I just thought i show you how to start an engine on its own. Couldnt find any Tutorials on Youtube of how to start up an engine. hope this video was helpful to those who may not have done this before. Enjoy!





1979 Chevy 350 Start/Run
Here's a 1979 Chevy 350 with a 650 Holley spreadbore carb. I plan to put this engine into my '75 Bug convertible on a custom chassis, of course.




Follow