A15 Startup in my 1200 Coupe
Startup video of my 1200 coupe project car.
Fresh A15, (standard size/spec pistons/rods/cam) rally grind cam, flows,
lightened flywheel, 40mm dellortos, oval port head (ported, planed, double
valves springs) running no Exhaust in
this video. soon to be custom EFI / ITB & megasquirt.
a12 turbo datsun 120y power runs
my datsun 120y turbo on the Dyno for tuning and a few power
runs, running a blowthrough setup on a
stock 37yo a12 engine
solex 32dis carb with 12a turbo carb hat
custom front mount 300x200 Intercooler and 2.5" piping
2.5" dump into 2" Exhaust
ihi rhf5 turbo @ 15psi
bosch 070 efi fuel pump
malpassi carb fuel reg
arp head studs
has turbo surge issues with the stock
turbo wastegate at 11psi. needs new
external wastegate setup.
this setup has made 80.1RWKW @ 15psi. quite impressive i reckon!
Datsun Turbo A12 Intercooled Twin Mikuni Side Draft Blow Through
This is a 1980 b310 datsun sunny with the original A12 (1171cm3)engine..I
got carried away and bolted on a garrett T2 turbocharger and modified some mikuni-solex phh
40mm sidedrafts to accept Boost..Power is a very usuable,fuel injected
type 113kw at the wheels on 12psi Boost at 6250 rpm..Engine modified and tuning
all inhouse by Allcraft Automotives Moorabbin 3189 Australia..
Stan's Datsun 1200 Race Engine
Here's a quick look at Stan's Datsun 1200 race engine as it was assembled
and Simtested at Costa Mesa R&D Automotive Machine.
www.engine-machining.com (949) 631-6376
Datsun A15 ITB EFI Startup
Another startup video of my custom EFI Setup in my Datsun 1200 Coupe.
Getting a bit closer now, have coolant sensor all sorted, O2 feedback
and got it idling (all be it a bit high @ 1500 rpm) still running super
rich, and so its
pretty smokey and back fires at higher revs. also very difficult to get it
its cranking....... Megasquirt is hard work, but its DIY so be happy when I
get there in the end :)
Datsun 1000 (VB10) A10 engine start up in box trailer v2.wmv
I recently bought an old A10 engine with 4 speed box for $84 on ebay. It
had been sitting out in the weather and has not run for a long long time.
Curious whether a rebuild was immediately required (or not) I hooked up
some fuel and started it up in the back of the box trailer it arrived in.
Was quite surprised how well it ran :-)
Datsun 1200 supercharged
this is my datsun 1200 ute which is for sale. its a supercharged a12. has
custom mandrel bent extractors, custom inlet manifold, aisin 500 s/c, 320
holley, 2inch Exhaust, cc oval port
head which has been lightly shaved, new head gasket only 2 months old,
triple core radiator, 10 inch thermo fan, mongoose immobiliser. Boost gauge in dash, original seats neat
interior, personalised plates read NIZ12 lowered suspension on front and 2
inch blocks in the rear, disc brake front drum rear. The drivers side sill
will need replacing. i have tried to show everything important in the video
Datsun 1000 `67 B10 Sunny A15 Turbo
This is a few pics of my 1000 2 door,
I bought her 15 Yrs ago with 37,000 miles on the clock (one granny owner)
She now has 55,000 miles and 120 rwkw (A15T 30psi.) and a celica 5 speed.
Revving my Datsun once warmed up. Notice some standoff from the nearest
barrel, also pops a bit at idle from that one.
Nissan A14 engine smooth run.
Join Maker Studios!
Click here to see if your channel qualifies for RPM Network/Maker Studios:
Nissan A14 engine from Nissan Vanette minivan.
Gearbox 4-speed manual, top speed 140 Km/h.
Datsun 1000 & worked 1200cc engine
Datsun 1000 with a worked A12. Initial start-up after the first round of
adjustments. This isn't nearly full throttle, I'll follow up with another
video of when it's running a little better. You should get an idea of how
worked the engine is though.
Still need to get jets, chokes, rocker arms etc looked at as it doesn't
respond to the throttle as well as it should [it's also running rich].
Sorry about the poor quality footage.