Bimmian.com 3M DI-NOC - Carbon Fiber Wrap
Now you can give ANY surface in your BMW the Carbon Fiber look with our high quality 3M™ DI-NOC™ adhesive-backed carbon vinyl!
SHOP NOW: https;//bimmian.com/CFF
This introduction video from bimmian.com will show you how.
What is 3M™ DI-NOC™?
MADE IN JAPAN, 3M™ DI-NOC™ is a high-end vinyl from 3M™. The vinyl can be installed on almost any surface, regardless of the curvature. There are unlimited applications, from the interior of your car to the back of your laptop.
3M™ DI-NOC™ gives a dry carbon look. Contrary to initial belief, carbon fiber DI-NOC™ is not just a printed carbon fiber pattern, but in fact has a three-dimensional texture to it. This allows it to reflect light the same way that real carbon fiber would, making it the best real-world alternative to carbon fiber when you just want the look without paying the high cost of real Carbon Fiber.
3M DI-NOC has a matte texture contrary to the usual glossy carbon fiber look. Make your vehicle stand out from the crowd with this unique look.
3M DI-NOC has an actual texture to it. That's what makes it better than all of the other carbon fiber films out there. It looks like real Carbon Fiber from any angle.
Indoor and outdoor:
3M™ DI-NOC™ can be used both indoors and outdoors. The material has been tested to last about 3-4 years outdoors and 12 years indoors. It is also Water resistant.
Can be applied to almost any surface:
3M™ DI-NOC™ film has been tested to adhere to wood, mortar, stone, metal, glass, plastic, and even itself. Carbon you hood, interior trim, engine components and more!
Easy to use:
3M™ DI-NOC™ films have 3M™ Comply adhesive air release channels for fast, easy, and virtually bubble-free application.
Self-adhesive back with 3M™ Comply adhesive for great adhesion to most surfaces. Enhance the adhesion by warming the material with a hair dryer or heat gun.
e39 Center Console Removal & Vinyl Wrap
How to remove the center console on e39 and wrap it with Carbon Fiber Vinyl
step by step.
4D Carbon Fiber Vinyl Install on Pillars
This video is about Installing 4D Carbon Fiber Vinyl on Pillars of a 2002
Ford Focus. They were worn out and needed some updating. I covered the
existing trim pieces and cut to fit. I go into some detail of mistakes that
people make when doing this themselves. Subscribe to my page to see more
upcoming projects (wrapping mirrors and interior parts)
5d super gloss carbon fiber vinyl (Use in the interior)
5D carbon is car vinyl film new generation. This film is very similar to
real carbon. Has a good glossy Shine. 5D carbon fiber vinyl can be used in
car tuning in the exterior and in the interior.
You can buy this film on ebay: http://goo.gl/oUMCor
Carbon Fiber Key Fob Skins for BMW and MINI
Give your BMW or MINI Key a Carbon Fiber Finish with this Easy to install
SHOP NOW: https://bimmian.com/CKC
If your Key Fob is worn out or scratched make it look like new again OR
protect your investment from damage.
Key Fobs are easily scratched and worn over time by constant use. They are
the one part of your BMW that is used everyday. Loose change in pockets or
even just the constant rubbing and damage from oils in your skin wear at
the surface of the Key over time. Refurbish a damaged key in minutes with
this Key Fob overlay kit.
Each set comes with TWO OVERLAYS so you can do both keys for your vehicle
or keep an extra to renew the overlay in the future.
The realistic Carbon Fiber finish is not a sticker. These are manufactured
from REAL 3M Di-Noc(TM)