All stock besides a Aero Turbine Exhaust and a Aero Turbine 4" Exhaust tip. I could went with duals but everyone has that so I went with a real clean set-up and im pleased. But I was strongly considering a Flowmaster like i had on my old jeep.......
Aero Turbine Muffler: How The Aero Performance Muffler Works
This video shows you just how the Aero Turbine Muffler from Aero Exhaust works. If you are looking for a
performance muffler the Aero Turbine Muffler is better than Cherry Bomb, Dynomax, Magnaflow,
Gibson, Flowmaster and others. Visit Parley's DIesel Performance for all
your performance Exhaust upgrades.
2007 Silverado BURNOUT! 5.3L Z71 4x4 ASPHALT DESTRUCTION!!
2007 Chevy Silverado Crew Cab 5.3L Z71 4x4.
Had Maxxis Buckshot Mudders 275/70 R17 on the truck. They had about 32,000
miles on them. Ran em hard and did plenty of donuts and burnouts with em,
so I'd say they lasted pretty well!
Performance mods include K&N Intake, dual flowmaster Exhaust, Gibson headers and HP custom tune.
Be sure to check us out on Facebook at Triple-X Motorsports & Outdoors for
all the latest updates!
BEST of Start Up sounds!! More than 70 Exhaust Sounds!
To celebrate my 600th video, I have made this compilation: probably all the
start up sounds from supercars I've recorded in the past years. It's the
largest start-up sound compilation on YouTube right now! I have put them
together in one video with more than 70 start up sounds!
What's you favorite start up sound? Let me know by leaving a comment
1st Channel: http://www.YouTube.com/GUMBAL
2nd Channel: http://www.YouTube.com/GUMBALTV
3rd Channel: http://www.YouTube.com/CarChannelClassic
Thanks you for watching my videos. All feedback on my videos are
appreciated! Don't forget to like the video and subscribe to my channel.
More videos coming up!
Aero Turbine 3030xl muffler 5.3L GMC Sierra
The 3030xl (resonated) Aero Turbine muffler on my stock 2003 gmc sierra
5.3L. Muffler was put in the same location as stock muffler with the same
tailpipe. basic muffler swap. Really enjoy the sound i get from it. its
plenty loud withought being overwhelming, and only has a little bit of
drone that you get used to in 5th gear on the highway around 2000 rpm.
Sounds awesome and different from the big brands! would highly recommend!!
GoPro doesnt do it justice but gives you an idea
Flowmaster Cat-Back Exhaust Install on 2011 GMC Sierra
Installation of a Flowmaster Force II Cat-Back Exhaust (#817523) on a 2011 GMC Sierra.
I made this video because I was researching installing one of these on my
truck and I couldn't find anything for a GM Truck. I saw some Mustangs, some Camaros, some Ford trucks, etc.
But nobody had documented what it would be like for a GM truck. So here
you go. All in all, it was pretty easy and only took a couple hours. I
can't promise how close they are, but the instructions and kit were for
2007-2012 GM Trucks. So this would most likely apply to them as well, with
perhaps a few deviations.
Also, sorry for the fact that it's all close ups, but when your truck is on
ramps and your lying underneath it you can only zoom out so far.
[15 Oct 13] One more thing as a note on warranties. Here is a snippet
from the Flowmaster FAQ:
"There are some modifications that have the potential to void a vehicle's
factory warranty, but modifying the Exhaust system after the catalytic converter is
not one of them. All Flowmaster Exhaust systems are designed vehicle specific
and do not violate manufacturers factory warranty. If you're having
problems regarding this issue, please contact www.sema.org for more
information regarding consumer's rights on performance aftermarket parts."
Flowmaster Super 44 on a 2004 Jeep Grand Cherokee 4.7V8
58 degrees outside, Bone stock except a K&N FIPK Intake and a Flowmaster
Super 44, I only use Mobile 1Full Syn oil. I love this Exhaust, I get questioned all the time or I get
that Jeep sounds healthy. It was taken in a parking lot so i cant get it on
it too much, but i think you'll get the point. I bought it threw JEGS for
about 80.00. In case any one asks the lights are arctic white low beams and
jdm yellow fog lights all by NOYKA, http://www.eautoworks.com/.
Production of the G&G GP exhaust for the Yamaha R6
Have you ever wondered, how your G&G GP Exhaust is produced? This video shows a couple
of the steps in the process of creating your Exhaust. All our Exhausts are hand-made in Italy, according to
high standards. Of course, we are always ready to answer all your
We receive a lot of comments about the fact that no welding gloves are
used. Our main goal was to show the process as well as we could, and the
decision was made not to use gloves for once. Rest assured that our welders
normally use protective gear. We thank you for your concern for our
Check www.gegshop.nl for our different GP Exhausts.