Drag Racing 1/4 Mile times 0-60 Dyno Fast Cars Muscle Cars

Drag Race - Duramax Diesel Mid 11's @ 121 MPH

Running mid 11's at 121 MPH!


 


More Videos...


Duramax Diesel beating a Vette - 12.10 @ 116 MPH
Duramax winning a drag racing against a Vette at high altitude





Duramax Drag Racing
10.79@127 in Boise, Idaho





DURAMAX DIESEL SAND RAIL
DVDs & APPAREL - http://www.bustedknuckle.com The Merchant Auto Duramax Diesel Sand rail was rolling coal at the 2014 Griztek snow challenge. It has a 700hp Duramax and a powerglide transmission. Follow us on Facebook - http://www.facebook.com/bustedknucklefilms





Smokin' Gun Diesel Drag Race Truck, huge burnout! June 2009 Calgary
CanadaMotorSports Huge burnout and a pretty decent 1/4 mile pass for a full size former highway transport truck. Smokin' Gun is Twin turbo, Supercharged, and InterCharged Detroit Diesel 8V92 1968 Kenworth drag truck. Just in case that isn't enough power, there's also a 1200 hp shot of Nitrous Oxide to give it that extra kick. It makes 3100 hp to move 9500 lbs down the 1/4 mile in less than 12.5 seconds, and through the traps at over 120 mph! This pass is a 12.91 103.35 MPH pass at Race City... not bad! copyright 2011 AVS Inc





RUN AWAY Detroit Diesel! 453-T
DD 453-T runs away! rack gets stuck on valve cover. almost lost some fingers too, it was all i could find. F'ed up new turbo compressor wheel, was only damage thankfully!





Duramax breaks tie rod drag racing, keeps going! Thursday Night Lightz 2012
Duramax diesel truck breaks tie rod drag racing, keeps going down the drag strip! Thursday Night Lightz, Edgewater 6-14-12. Check out my channel for more video of this truck in action, more TNL grudge racing and more action from Edgewater drag strip, Cincinnati, Ohio: http://www.youtube.com/user/wyldfantasies If you just want to see more badass Diesel Truck, black smoking action, check out my blog: http://bigdslpwr.blogspot.com





MARS 5HP DIESEL ENGINE - 1st Start Up in 50 Years!
Watch as an early 1940's MARS Diesel engine is fired up after 50 years. Originally acquired from a cane farmer in Nambour, Queensland, Australia in the 1970's, this engine sat in careful custody with another three owners before finally retiring with me. MARS engines were made by the MARS Machine Tool Manufacturing Company in Brisbane, Australia and were preceded by the horizontal and vertical Rapson and Dutton engine, made by the same company under the Rapson and Dutton company name. MARS engines are not Lister clones. Mars engines are bigger, heavier and more robust than Lister engines. When you listen to a Lister and then to a MARS you will agree. This engine has a 3 " diameter crankshaft and not one component is interchangeable with a Lister. MARS engines were commonly used in industrial situations such as factories to power line shafts which powered a number of machines, a task Lister engines had some trouble with apparently with their crankshafts twisting under the load on start up, and why this company made the Mars Diesel. 5 HP MARS engines were painted Maroon colour as standard from the factory although there are variations of colour in existence. 8 HP engines were a different colour. This engine has not run since the original owner sold it in the early 1970's. Apparently it had not run for some years before that. The second owner sadly passed away before restoring it and it sat in a shed untouched with the third owner. Close friend and temporary fourth owner, Simon Devere, assisted actively in the mechanical restoration when I purchased it and assisted in the first start after its mechanical restoration. This man is a genius when it comes to diesel engines and he has the nickname "The Lister Whisperer" for good reason. Thanks "Slippery". This engine appears to have not done much work judging by its internals. Work to the engine includes new rings, liner/cylinder hone (the original factory liner had indiscernible wear in it), new valve guides made to original specs, new valves to original specs (original was bent and caused damage to the guide) , new big end Babbit bearing, new conrod bush, very light head machine to ensure true flatness, new internal oil pipes, new head gasket, new oil gaskets, new high pressure line, new welch plugs in the head and new oil pickup. There are still remnants of the original factory maroon paint on it that have survived the years of weathering out in the cane fields. Cosmetic restoration is planned shortly to bring it back to its original livery. It will be mated with a steel transporter to emphasise its industrial heritage and will be rallied with pride. Video of the finished engine on transporter will be posted when it is done. Enjoy and please share if you like. This is the only video of a Mars engine running to this date anywhere. Hope to see more. Cheers Phil





Awesome V12 Monster diesel engine Awake and Alive startup
Awesome V12 Monster diesel engine Awake and Alive startup The first V-type engine (a 2-cylinder vee twin) was built in 1889 by Daimler, to a design by Wilhelm Maybach. By 1903 V8 engines were being produced for motor boat racing by the Société Antoinette to designs by Léon Levavasseur, building on experience gained with in-line four-cylinder engines. In 1904, the Putney Motor Works completed a new V12 marine racing engine -- the first V12 engine produced for any purpose.[2] Known as the 'Craig-Dörwald' engine after Putney's founding partners, the engine mounted pairs of L-head cylinders at a 90 degree included angle on an aluminium crankcase, using the same cylinder pairs that powered the company's standard 2-cylinder car. A single camshaft mounted in the central vee operated the valves directly. As in many marine engines, the camshaft could be slid longitudinally to engage a second set of cams, giving valve timing that reversed the engine's rotation to achieve astern propulsion. "Starting is by pumping a charge into each cylinder and switching on the trembler coils. A sliding camshaft gave direct reversing. The camshaft has fluted webs and main bearings in graduated thickness from the largest at the flywheel end."[3] Displacing 1,119.9 cuin (18,352 cc) (bore and stroke of 4.875" x 5" (123.8 x 127 mm)), the engine weighed 950 pounds (430 kg) and developed 150 bhp (110 kW). Little is known of the engine's achievements in the 40-foot hull for which it was intended, while a scheme to use the engine to power heavy freight vehicles never came to fruition.[2] One V12 Dörwald marine engine was found still running in a Hong Kong junk in the late-1960s. Two more V12s appeared in the 1909-10 motor boat racing season. The Lamb Boat & Engine Company of Clinton, Iowa built a 1,558.6 cuin (25,541 cc (5.25" x 6" (133.4 x 152.4 mm)) engine for the company's 32-foot Lamb IV. It weighed in at 2,114 pounds (959 kg). No weight is known for the massive 3,463.6 cuin (56,758 cc) (7" x 7.5" (177.8 x 190.5 mm)) F-head engine built by the Orleans Motor Company. Output is quoted as "nearly 400 bhp (300 kW)". By 1914, when Panhard built two 2,356.2 cuin (38,611 cc) (5" x 10" (127 x 254 mm)) engines with four-valve cylinder heads the V12 was well established in motor boat racing.[2] In automobiles, V12 engines have not been common due to their complexity and cost. They are used almost exclusively in expensive sports and luxury cars because of their power, smoother operation and distinctive sound. ▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ ▬▬ ★ MORE INTERESTING VIDEOS: http://www.youtube.com/watch?v=yrbwGmtZ8pM&list=UUYH8swcp71EHt-88lkaMDTQ ★ SUBSCRIBE: http://goo.gl/GynuUU ★ Follow my Twitter: https://twitter.com/GeorgeDominik1 ★ Thanks For Watching ★ ★ Post comment , share and tell us what u think ★ ▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ ▬▬





MF Duramax diesel
MF with Duramax diesel and mechanical diesel injection feul pump, creator is Lammert ter Heide. Is is an tractorpulling tractor.





Transfer-Dump Race: The Complete Run
Mark Tarascou and his Pete 359 is seen participating in a transfer-dump competiton at the 2011 Truckin' For Kids Truck Show. Although there were a few glitches, it was still a good show. For those not familiar with dump trucks like these, they are set up with a system that allows the driver to back the truck up while they are standing behind it to make attaching the towbar easier. The driver puts the truck in reverse gear and shuts the engine off. At the rear is a switch or a button that is used to engage the starter motor on the engine without starting the truck. Since the transmission is in reverse, as the starter motor turns the engine it also turns the driveline and backs the truck up. I'm not a trucker so I don't know what this system or technique is called, but that is how it works. Thanks for watching. Please rate and share this video with your friends. Shot on 9-25-11.





2.5 TON CHEVY DURAMAX DIESEL DOIN A BURNOUT ON TWO CARS
CHOPS3131 DMAX1 "Chevy 4x4" bogger "54 boggers" mudding "keith daley" "shilo ridge" 54's duramax "monster truck" "efi live" "efi tuned duramax" "lots of smoke" "fast duramax" "hood stack" "Industrial Injection" "120hp injectors" "BD Max turbo" "Airdog 250" "Suncoast stage 5 trans" "huge duramax" "monster duramax" "huge 4x4" boggers "show truck" "trucks gone wild" "mud truck" 4-linked "2.5 TON"





My weak 2005 Chevy Duramax diesel smokeshow
I just put on 2 stickers for 20 more horsepower and a carbon fiber ashtray for weight reduction.





TRIPLE TURBO DIESEL DRAGSTER~ INTERNATIONAL DT466 540C.I. 3000HP @ RT66 FIRST RUN
THIS IS THE FIRST INITIAL RUN





Cummins S10 vs. Duramax Camaro
Brandon's Cummins S10 drag racing at Scheid Diesel's eXtravaganza 2009. Round #2 rematch put me up against the same first gen Duramax powered Camaro Z28. I turned the Nitrous on for this pass and hurt traction even more.





Duramax Diesel
2008 LMM Duramax raging around.





Which car is faster? Which Car is Faster?




Similar 1/4 mile timeslips to browse:

90 Volvo 240 DL : 11.950 @ 135.000
kapono, Engine: rb26dett, Turbos: 2 Tires: big


1956 Studebaker Hawk Power Hawk: 15.475 @ 91.790
David Starr, Engine: Studebaker 289, Supercharger: Paxton SN60 Tires: 255/60R15


2008 Ford Edge fwd: 15.836 @ 87.750
James Mauter,


2007 Ford Edge SEL Plus AWD: 16.010 @ 86.030
NA,


2007 Ford Edge : 16.210 @ 85.810
NA,


2008 Toyota Prius : 16.990 @ 81.000
Ben Uhron,


2011 Toyota Prius III: 17.310 @ 80.210
NA, Engine: Inline 4, AC Electric Motors: 98HP, Tires: Yokohama Avid S33D


1990 Volvo 240 DL : 17.400 @ 79.100
Joe, Engine: 2.3 B230, Tires: 205/60/15


2004 Toyota Prius : 17.700 @ 79.000
CD,


2006 Toyota Prius Hybrid: 17.810 @ 77.910
NA,


2003 Toyota Prius NHW11: 18.500 @ 72.000
Bob Wilson,


 


©2014 DragTimes - Disclaimer