Electric Exhaust Cutout 5.2 V8 ZJ Grand Cherokee LOUD!
DG Motors: 666c West Hoffman Ave. Lindenhurst, NY 11757
Phone: (631) 957-8464
Here at DG Motors we just installed a Race Ready Performance Electric Exhaust Cutout Stainless Steel No Welding
Kit on our very own 1996 V8 Grand Cherokee Limited. This is for all you
American Muscle lovers out there! With the flip of a switch our cameraman
can choose when to produce pure music and be noticed or when to hang back
with low rumble of the Flowmaster Super 44 Series Muffler. Installed before
the muffler and after the cat, this cutout is noticeably louder and the
Jeep is more responsive down low as well as up top. Stay tuned for more!
Thank You Race Ready Performance!!! The no weld kit, everything stainless
steel (clamps, y-pipe, turn-down tip, nuts and bolts) all shipped for $313
UPS Ground (took 4-5 days to ship)
Goat clearing its throat
A short clip of standing on the gas pedal. No brakes, just the 2,800 rpm
flash stall converter doing it's job.
QTP Cutouts on Stacey David's Rat Roadster
Stacey David show how to install Quick Time Performance Electric Exhaust Cutouts on the Rat Roadster on his show
Gearz. Shown on Speed Channel.
Flip the switch and go from quiet to riot in seconds.
More info can be found at:
1968 Charger Exhaust Cut Outs
Testing the Exhaust cut outs on the
Charger to see what the different sounds were like. Sorry about the wobbly
camera - its hard to balance an iphone on the road.
Ford F150 5.4: QTP electric exhaust
Video of my new QTP electric Exhaust
cutout on my 2007 Ford F150 5.4 Lariat. Thought I would show a start open,
(via remote start is what you hear) than a close of the cutout.
--This video was uploaded from my DROID X.
Badlanz Demonstration of E-Cutout
This video shows the Badlanz "Full FLow" E-cutout in action. 4 seconds to
open and 4 seconds to close. Stop the butterfly in any position.
Open and closing cut-outs.
Here's a quick vid of what my truck sounds like with the cut-outs open and
the cut-outs closed. Exhaust is an
off-road X-pipe split into two cutouts that exit either side of the truck.
When closed it routes both banks to a straight through magnaflow and dumps
over the rear axle.