2007 Drag Week Fastest Street Car in America. Making a Dyno pull with 20 lbs. of Boost and putting out just under 1500 rear wheel horsepower. The car ran a 7.64 quarter mile ET and drove over 1200 miles in one week.
The Professor Camaro dyno tune at Dakota Digital
Dave and Karen Leisinger's Professor Camaro stretches its legs on the
Dakota Digital chassis Dyno. Warren Johnson Racing
assembled the 500-in LSR engine. Watch for the car in Columbus competing
for The Goodguys Street Machine of the Year award and dominating autocross
events across the country!
2,900+hp ProCharged BBC on methanol
This is an engine combination we built for a TOP SPORTSMAN racer customer.
This is a great alternative for TOP DRAGSTER/TOP SPORTSMAN classes that are
tired of always working on their engines instead of racing. This engine
combo can be built to fill different power needs.
Hot Rod Drag Week Promotional Video
http://www.1320video.com/store/dvd/ (Drag Week DVD's available!) A video
for the Pittsburgh Autorama booth with cars owned by Jeff Lutz, Larry
Larson & Denny Terzich illustrating the main elements that make Drag Week
what it is.
1460+H.P. -CAMARO- Street Car- WICKED FAST-Steve Morris-ProCharged
Steve Morris Built & Tuned 447 C.I. Small BLock - F3-R Procharger- On E-98
Ethanol Fuel, C&S Carb extensively worked and tuned. Can drive 30 minutes
on the highway to the track and run 5.32 @ 144 On a Conservative Mild
tune.. Will run 4's. POWER WINDOWS,LOCKS & TILT WHEEL.... VERY CLEAN AND
SLICK... ALL FRESH, POWERGLIDE TRANS.,9" REAR ,3.60 GEARS, 40 SPLINE GUN
DRILLED AXLES,PRO MOD STYLE 4 LINK, ADJUSTABLES FRONT AND REAR, 4 WHEEL
AEROSPACE DISC , ALUMINUM STRANG CENTER SECTION, ALL TUNED WITH LAP TOP
THROUGH MSD 7535 PROGRAMMABLE... MUCH MORE.
ProRides - Project Sick Seconds Inaugural test run - Denny Terzich Procharged Camaro
Steve Roth (driver) and Gary Pocratsky lined up our Camaro for a foot brake launch
and 50% throttle run to break in the car. The set up was with very little
Boost. More runs to come as we go.
The car will debut at PRI show 2010 in the ProCharger booth. The engine is
a 589 Cubic Inch Big Chevy with a F3R ProCharger. The car will be driven
1200 miles between 4 dragstrips at Hot Rod Magazine's Drag Week. Our last
car won in 2007 with the black 1967 Camaro.
Jesse's F1-R Procharged 69 Camaro 565 Big Block
Here is a clip of my F1-R procharged 565 inch Dart big block Camaro at a Winchester Bay, Or
burnout contest during Kool April Nights 2011. AFR 345cc aluminum heads,
all the goodies, full roller. Shot from different angles and edited for
youtube. initially an official stopped me short on the burnout, so i asked
to go again and this was the result. Hope you like it!
2500 HP dyno
I think this is a Buik but not too sure. If anyone knows then correct me
please. Big HP Dyno
run using 2500 HP turbine unit.
1967 Chevy Camaro twin-turbo dyno run. 1000+ horsepower.
1967 Chevy Camaro on
the Dynojet Dyno at Mach V Motorsports.
This car is very heavily modified, with many more modifications than I can
list here. The block is 410 cubic inches, all aluminum. The turbos are Borg Warner 80mm units. Engine
management is a FAST XFI system. It's making 16 psi of Boost in this video, but target Boost at the drag strip is around 45 psi.
Our Dynojet can record
a maximum of 1000 hp and 1000 ft-lb of torque.
I'm sorry about the video quality on this one; we didn't have our usual
high-def cameras on hand.
SAE correction 1.00.
Mach V Motorsports
45690 Elmwood Ct. #170
Sterling, VA 20166
SICK Procharged Malibu!!! 7.82 @ 189MPH
1980 Malibu owned by Scott Smith of Kansas City, powered by a 509 Steve
Morris big block Chevy & blown by a Procharger F3 135 Supercharger. These were the best passes on the
car at the time (7.82 @ 189mph), it sure is a beast! He was also winner of
the Drag Week 2011 Big Block Power Adder class!
Procharger BBC 1st start @ Eric Stubbs' TURBO shop. (E.S.R.)
ADRL XTF racer, Eric Stubbs, of Eric Stubbs Racing fires off the latest BBC
Procharged project that he has done the fab work for and will be doing the
ERIC is on the initial phase of gathering data and getting this baby tuned
up enough to go and gather some Track Data. This blower is almost as large
as the BBC engine. The 2010 track data is coming soon. More VIDS to come.
E.S.R. is the PLACE to BE if you are building a ProCharged or turbocharged Street OR Race Car. ESR is near
Houston,Tx @ 281.468.1805.