SDP Autosport inc. Built this engine that can go at 11,000 rpm and still working on 91 octane fuel. The bottom is almost like a stock but head work is crazy. We made new runner with the Dyno sheet you seen. Head porting is very nice as you can see but we most keep our secret thank you for looking.
And please visit our web site to see what else we can do !!!
GSR B18c TWM ITB First Start Up
TWM ITB's, swapped them in without have to modifying much of anything expect for the fuel lines. Each runner already had its own vaccum line that i used for the map sensor, temp sensor, brake Booster and PVC.
7-Port Classic Mini 1380cc with Twin 45 Webbers
7-Port Classic Mini 1380cc with Twin Webbers
Engine spec:
1380cc A+ with Omega pistons - 7cc dish
EN40B steel crank, cross drilled nitroided ectect
Steel rods - shot peened and stress relived
Block stress relived and drilled out 5/16 gearbox bolts 11 head studs drilled
Centre main strap
All new acl bearings though out
Arp bolt though out
New MED flywheel, back plate, race clutch, dynamic crank pulley
Belt drive kit
296 billet cam
Alloy 7 port with 37.5mm inlets and 31mm Exhaust rimflow valves,double valve springs
MED roller rockers
Twin Webber 45s
Maniflow stage 3.5 Exhaust manifold
Aldon Red dizzy
Hi-torque starter motor
SCCR gearbox with 1.1 SC drop gears with semi-straight cut LSD
Engine built by Slark Race Engineering
From J19 Mini Club, nr Bristol UK
Polycarbonate Windows by ACW Motorsport Plastics
www.acwmotorsportplastics.co.uk
800hp evo 8
Low Boost setting 20 psi 600 hp as is ,pump gas ,2.3 stroker MD,ams 850r , built 5 speed tranny ,etc etc built and tuned by ma-developments UK , Thank you carbon brake pads looool,
Thank you
