B18C5 R-DOT Project Day 8
Flywheel, Clutch install. Engine drop in. Engine priming, first start and
Dyno. As well as recap
of ref process.
For other photos of the vehicle this engine was dropped into featuring the
suspension, interior or other supplemental components, please visit
Products used in this video include...
CC Ultra Light weight flywheel http://www.inlinefour.com/coclfl.html
CC 2100 Clutch http://www.inlinefour.com/coclstsest2.html
IL4's i-Tune service: http://www.inlinefour.com/Dynoservice.html
98 spec ITR header http://www.inlinefour.com/jdm98spectyp.html *special
integra vs srt4
Launch Fail! LOL... but good race anyways!
hope you like it! coment and subscribe for more racing videos and some
other good stuff... :D
Type R Integra Satin Black with Carbon doors and hood and spoiler front and
rear. 242 hp and 217 nm torque running a B20Vtec all motor engine running
pump fuel 95 octane. Turns out the 1040 kilograms weight was from an
uncalibrated weight machine....I'll update on the weight with pictures or
videos later.....and it has come a long way from Champion White (what
everyone mostly has for a Typical Type R, to an Imola Orange Integra with
Carbon doors, to the current theme of Satin Black done in 2008-2009) Bare
bones Integra without the ABS, Power steering, or speakers or power locks
or windows. Pure driving machine. Even the dash and door cards were
stripped to bare plastics. Fully welded 8 point certified roll cage and
SEAM WELDED body and chassis including some body bracing added via welding.
63 percent front weighted 37 percent rear weight distribution. Using it as
a DAILY RIDE in Thailand.
Californiadad's Turbo Integra GSR 1.8L 475whp
Here is just a basic drive out on the streets, just happen to run into a
couple of bikes that wanted to play. Too back I still get no traction out
of the hole. even with slicks! Other wise I would of been able to catch and
pass that bike sooner.
Team 1320 382whp All Motor K26 Eg Getting Ready For 2011 IDRC West Coast Nationals
Idle and walking around of Team 1320's All Motor Street Car. Getting her
readyy to race IDRC at Fontana auto club aka funtucky April 23rd. 67mm
kinsler ITB w/ eight injector set up. primary's run at idle and low RPM and
secondary top feed injection transition on at high RPM for better
atomization. Custom GO-Powermotorsport / Webcam single lobe vtec killer
camshafts, machined factory roller rockers, skunk2 valve train, GO-Pwr 2.6L
106.xxmm crankshaft k24stroker kit, 90mm arias aluminum 15:5:1 compression
ratio pistons. k24 GRP aluminum rods, aebs sleeves, port flow head, aem
ems, race pack data log and display dash, rywire milspec wiring harness,
fuel lab fuel system with x8 ID injectors, meziere external water pump,
Clutchmasters FX725 twin disc clutch and flywheel kit, Quaife LSD
differential, 4.7fd, 1-4 PAR dog box transmission. GO-Pwr hood exit header,
Q16 race gas skunk2 suspension and camber kit. hasport mounts, 8.50 et's
and slower roll cage done by GO-PWRmotorsports.