My 1985 Trans Am 2007-Preasent Project
just threw random songs on it. nothing major.
1985 Pontiac Firebird/T/A
Engine: 305 Small Block Chevrolet Throttle Body Injection [5.0 Liter V8]
240,000 miles 210hp Timing set at 18 degrees
Transmission: 700R4 Automatic with Overdrive 240,000 miles
Differential: 7 1/2, Limited slip
Exhaust system: custom 2 1/4 to the 3
inch Y-Pipe NO CAT,
stock 2 inch back piping to the muffler
[Upgrade: 3 inch pipe all the way to the MagnaFlow muffler, two 2.5 inch
out to dual 3 inch tips}
1991 Throttle Body Injection Wiring Harness.
5 point racing seat belts for both driver and passenger.
Rear seats were taken out
My dad welded the roll-cage in it.
1991 Steering column with Computer Chip key
Stock steering wheel
dual American Bass DX subwoofers.
PONTIAC FIREBIRD TRANSAM
＞火の鳥さん '89 TRANSAM GTA Black with Food decal
＞こもらーさん '87 TRANSAM Black/Gold
＞ysz.さん '89 TRANSAM Blue/Silver
＞オヤジさん '90 TRANSAM GTA Black
89 Trans Am 400 Burnout. I rebuilt this car from scratch.
1989 Pontiac Trans Am GTA with a Pontiac 6.6 400cid engine that has been
Completely balanced and blueprinted by "War Path Performance" in Opa
Locka, FL. Engine is well over 400 HP. This car is a rocket. Holly
4150 Performance Street Carb (770 cfm 4 barrel Avenger). Edelbrock
performer intake. MSD high energy distributor & coil. 8mm high
performance ignition wires. Ram Air powder coated D Port Manifolds. Ram
Air 3 Competition cam with triple coil competition rocker arms. 60 over
forged pistons. Ferrera Stainless steel valves with hardened valve seats &
3 angle valve job. High output 120 amp alternator. Ron Davis Racing
Radiator with 2500 cfm each fan. Optima Gel Cell High Amp Battery. turbo 350 transmission with 2500 Stall
Converter with Shift Kit which has been completely rebuilt. High torque
mini starter. True Dual Exhaust
flowmaster from front to back stainless steel front and rear vented
slotted disc brakes with high performance pads with all new wheel bearings
and seals. EVERYTHING THAT COULD BEEN DONE FOR THIS CAR .... HAS BEEN
1987 Trans Am 355ci TPI first drive...
This is a short vid of my 87 Trans Am after I finally got the engine
running right. Before it would not idle but I figured out I had the valve
spring rocker arms tightened too tight. It is a 355ci small block chevy
with crappy truck heads along with a LT1 cam and a Tuned Port Injection
intake manifold. Exhaust is
Flowmaster, but I do not know what series. When the car is near the
phone/camera, you can hear the loud hissing coming from the engine sucking
in all that air! This is the first drive since I removed the 305 so I am
still getting used to the pedal with power! The smoke is from the
injectors running a bit rich since I had the fuel pressure turned up a bit
high. This is also a good vid to see my sequential tailights!