1994 Beretta cammed 3400 open headers
1994 Chevy Beretta, 3400 bored .040 over, Comp Cams street cam, Pacesetter
headers, 65mm TCE throttle body, FFP underdrive pulley, Z06 yellow valve
springs with heads milled .010, Tayler Thundervolt 8.5mm wires, MSD coils,
Autolite Iridium plugs, A/C delete, EGR delete, O2 sensor delete.
Open headers. Sound quality isn't the greatest, just using a low grade
1994 Chevy Beretta 3100 Flowmaster exhaust
1994 Chevy Beretta GTU conversion, 3100 V6, full 2.5" Exhaust, stock downpipe, no convertor or
resonator. Flowmaster Super 44 with Hooker dual 3" resonated tip. Short ram
intake installed with Weapon-R filter.
Other modifications to this point consist of: Taylor Thundervolt 8.2mm
wires, MSD coil packs, NGK Platinum plugs, Canuck Motorsports lowering
springs, ES sway bar links, strut-to-strut and strut-to-crossmember braces,
Baer drilled/slotted rotors with Cmax ceramic pads, and 17x7" Enkei EV5's
wrapped in 215/45 Sumitomo HTR ZII's.
Don't mind the smoke, car takes a while to warm up before it clears away.
Sounds much better in person, but this video does give a very good idea of
how the car does sound.
1991 Chevy Beretta GTZ Turbo
the turbo set up i used for my Beretta
GTZ 2.3l quad4 high output, a test drive after install and a test run with
5 psi first and second gear. i do not own the right to the song enjoy
How to build HORSEPOWER - Ford 461ci Windsor V8 by Dandy Engines
Engine specialists Dandy Engines building a small block Windsor 461ci
stroker for Pat Staplton. Follow the engine assembly as the guys aim to
make more than 820hp naturally aspirated on regular pump unleaded 98-RON.
Pat plans on putting this brute of an engine into a Ford Falcon XD/XF Ute.
[ http://dandyengines.com ]
Creative Commons music license CC 3.0
Jahzzar - Breaking Bad
V8 Aerostar ( 5.0 HO )
Ford should have made a V8 Aerostar. I got 5 mpg better than the 2.8L V6
5-spd, it sounds better, and its more fun to drive (power). Sitting 1 ½
inches lower with large swaybars made it handle like a car. I've had A LOT
of fun with this van, now it's time for a change. If you ever get a chance
to be part of the Hot Rod Power Tour I highly recommend it. It doesnt
matter if you do the long haul or just one venue, you wont regret it or
Model V8 engine electronic fuel injection
Scratch built 45cc V8 with Megasquirt MS2 fuel injection.made in the shed
with an old manual Bridgeport mill and a 95 year old lathe. Single fuel
injector made from Punto injector internals. Pressurised oil system,
drilled crank, alloy block, cast iron wet liners, vernier cam pulleys,
Walbro fuel pump, tungsten alloy flywheel, bead blasted and anodised
finish, throttle pos sensor on butterfly shaft, 24tooth trigger wheel for